Search results

Earthworks are the embankments and cuttings that allow a railway to maintain a certain line, level and grade through the landscape. Earth embankments consist of an engineered bank of earth that carries the railway above the natural ground. A cutting is used to carry the railway through ground with a natural level above the line of the railway. Modern (post 1960s) earthworks are carefully engineered to perform well. However, many railways run on earthworks that were constructed over 100 years ago without the use of mechanised plant. The quality of construction of older earthworks was often poor compared with present-day engineering practice. Ageing of the earthwork structures, and the greater demands of heavier and faster trains and climatic change, means that earthworks suffer ultimate and serviceability failures that can present operational difficulties. Older earthworks that fail or do not perform well require maintenance and repair, and sometimes complete replacement. This chapter explores the main engineering considerations for modern earthworks, and the challenges associated with older earthworks including their modes of failure and upgrade and repair.

Purpose – In this research, we have prepared activated carbon (AC) from the waste of banana peels (Musa acuminate L.) using potassium hydroxide (KOH) for carbon monoxide (CO) adsorption from motorcycle gas emission.

Design/Methodology/Approach – The activation was conducted using a chemical activator (KOH) at various concentrations of 1, 2, and 3 N for 1, 2, and 3 h, respectively. Characteristics of banana peels AC (BPAC) produced were analyzed using the Fourier-transform infra-red spectroscopy and scanning electron microscopy.

Findings – Results showed that KOH concentration and activation time strongly affected the CO adsorption and opening of the AC surface pore. There was an increase in the CO sorption when the KOH concentration was increased up to 3 N concentration. The highest CO adsorption from the emission occurred at 70.95% under KOH concentration of 3 N during the 3-h preparation.

Research Limitations/Implications – BPAC has been used as an adsorbent for only CO from motorcycle gas emission but not as an adsorbent for HC, NO, NO_x, or H₂S.

Practical Implications – BPAC can be used as the potential adsorbent for the removal of CO from motorcycle gas emission, and it is an environmental friendly, low cost, and easy to make adsorbent.

Originality/Value – In this study, the AC is made from biomass and is used in wastewater treatment, but limited studies are found on the removal of CO from motorcycle gas emission.

The impact of climate change towards water surface resources is crucial, particularly in developing and non-developing countries. Groundwater as a main water resource is thus an essential. However, contamination due to hydrocarbon spills affects the groundwater as a water resource, especially as a main source of drinking water. This chapter investigates the light non-aqueous phase liquid (LNAPL) penetrations in double-porosity soil with different moisture contents and with or without vibration impact. It also explains the LNAPL penetration phenomena by employing image analysis. The physical laboratory experiments were implemented using an acrylic cylinder, a mirror, toluene and a Nikon D90 DSLR digital camera. Prepared soil was poured in an acrylic cylinder and compressed with compressor until it became 10 cm in height. LNAPL was then poured instantaneously onto the acrylic cylinder that was filled with soil sample. The LNAPL penetration patterns were recorded and monitored using a Nikon D90 DSLR digital camera. The processing technique was conducted at predetermined time intervals using Surfer software and Matlab routine to plot the LNAPL pattern. The results showed that a higher penetration rate of LNAPL occurred with higher moisture content and without vibration impact. The penetration time for LNAPL to reach the bottom of the soil sample was found to be longer for the soil that had low moisture content and with vibration impact.

Purpose – In this study, the possibility of the application of rice husks for adsorbing Mn(II) ion in the water phase has been studied.

Design/Methodology/Approach – Experimental studies have been initiated by preparing activated carbon from rice husks. The activation of rice husks was done using both physical and chemical treatment methods through heating at 110 °C and washing with citric acid activator at 0.2 M, 0.4 M, and 0.6 M. The adsorption tests were conducted as two part tests: preliminary and primary. The preliminary test was conducted to choose the best condition of four independent variables, i.e., contact time (0–120 minutes), activator concentrations (0.2, 0.4, and 0.6 M), initial Mn(II) concentrations (10, 20, 50, 100, 200, and 400 mg/L), and adsorption temperatures (30, 47, and 67 °C).

Findings – By identifying the substituted groups using Fourier Transform Infrared Spectroscopy after activation with citric acid, it was found that the highest transmittance percentage was present in activated carbon with 0.2 M of citric acid. The best adsorption capacity and efficiency was 13.87 mg/g and 79.60%, respectively, which were obtained at 200 mg/L initial concentration with a 0.2 M citric acid concentration for 120 min contact time at 47 °C. These results lead to a conclusion that rice husks after activation with citric acid can be applied as an adsorbent for Mn(II) adsorption in the water phase.

Research Limitations/Implications – The activated carbon produced was only applicable for the adsorption of Mn(II) ions from the water phase, but not applicable for the adsorption of other heavy metals ions.

Practical Implications – Rice husks were potentially prepared as an adsorbent for Mn(II) ion adsorption in the water phase that was low cost, environmental friendly, and easy to prepare.

Originality/Value – Activated carbon prepared from biomass was mostly carried out using acids at high concentrations while the study was conducted using weak acids (citric acid) at low concentrations.

The evolution in developed countries has taken a role in global warming and natural disasters such as flash flood, El-Nino, earthquake and groundwater contamination. The underground storage tank leakage problems and spillage of hydrocarbon liquid leading to the contamination of non-aqueous phase liquids (NAPLs) into the groundwater could reduce the quality of groundwater. This chapter is intended to investigate the behaviour and the pattern of NAPL migrations in double-porosity soil under vibration and intact conditions. The experimental model is developed by using kaolin soil type S300 and toluene as NAPLs. The kaolin soil was mixed with 25% of moisture content to produce kaolin granules in the soil column and vibrate under 0.98 Hz of frequency within 60 seconds. As a result, both specimen liquids completely migrated to the bottom of soil column: sample 1 has higher permeability compared to sample 2. This is due to the fracture in double-porosity soil under vibration effect and loosened the soil structure in sample 1 compared to good intact soil sample 2 with stronger and compact soil structure. In conclusion, this study proves that the dangerous hydrocarbon NAPL migration in fractured double-porosity soil has very harmful effect on the environment and groundwater resources.

This chapter addresses the need for groundwater resource management in the arid and semiarid zones of Uzbekistan, broadly and specifically the potential to prolong the functional life of water wells by rehabilitating capacity and developing new methods and devices for cleaning and protecting well filter screens. The urgency of this concern is felt most deeply in areas lacking potable water, most notably the larger Aral region. If achieved, the result will facilitate access to adequate supplies of potable water in a region where the surface waters are seriously depleted and polluted. Springs that once bubbled to the surface to form oases were surrounded by life in the desert. Perhaps reliable water wells are the basis of tomorrow's new oases.

This chapter illustrates local responses to disaster and highlights the potential role of three community-based society organizations (CBSOs) – women’s groups, youth groups, and religious groups – as risk communicators in Bandung, Indonesia. A framework is modeled for CBSOs’ risk communication process in bridging the gap between the local government and the community. A set of indicators in social, economic, and institutional resilience activities (SIERA), with a scope of 45 disaster risk reduction (DRR) activities covering three different disaster periods was developed to characterize the process of the delivery of risk information by these CBSOs through their activities at subdistrict and ward levels. The data were collected through a questionnaire survey method using the SIERA approach. Each CBSO leader in a ward was surveyed about their perceptions of these 45 ongoing SIERA activities and their risk information source and dissemination process. Statistical analysis was applied to determine the relationship between variables such as periods of disaster and types of SIERA activities and its attributing factors (location, population, and dynamic of organizations in their locale) in finding variations of risk communication activity that may function for communities. Five risk communication processes of the CBSOs are identified; when their perceptions and ongoing activities are compared, activities such as dissemination of disaster risk information, conveying early warnings to their peers, and involvement of the local government have been carried out by these CBSOs. This indicates that CBSOs’ activities already have a certain degree of risk communication embedded in the communities. The results confirm that these CBSOs, through their social networks, can become active agents of change and bridge the communication gap between government and community. Thus, CBSOs’ risk communication provides the opportunity to contribute to the overall resilience-building and disaster risk reduction as part of people-centered actions and local responses to disasters.

This paper looks at the origins of Albert O. Hirschman’s distinctive approach to economic development. It argues that Hirschman’s style was the result of several, sequenced, influences. One was the impact of his brother-in-law, the Italian philosopher, Eugenio Colorni, who raised the curtain on a Renaissance approach to knowledge that privileged the importance of close observation. The second was an aversion to abstract theorizing, based in part on Hirschman’s distaste for what “theory” produced in the 1930s and 1940s. Finally, the paper suggests that the experience of looking at development experiences from the ground up while living and working on Colombia in the 1950s was pivotal. Thus, it was set of conceptual, political, and empirical influences that molded the classic work, The Strategy of Economic Development (1958).