Search results

The purpose of the paper is to model, analyze and control a new flux‐controllable stator‐permanent‐magnet brushless (PMBL) motor with skewed rotor.

A new flux‐controllable stator‐PMBL motor with skewed rotor is presented. The key of the proposed motor is to incorporate both direct current field windings and permanent magnets in the stator. By using a 2D multi‐slice finite element model, the electromagnetic performances such as flux linkage, self‐inductance and back‐EMF are obtained. To minimize the torque ripple, a vector control strategy is applied to the stator‐PMBL motor drive for the first time.

Some encouraging experimental results such as lower torque ripple and faster speed transients are achieved. It is shown that the three‐phase flux‐controllable stator‐PMBL motor, when properly designed and controlled, is an interesting candidate for traction drive systems especially for electrical vehicle operation.

The control method can also contribute the other type of stator‐PMBL machines to realize the low torque ripple.

Currently, lubrication analysis of piston ring is generally done under engine rated operating condition. However, the engine (such as the vehicle engine) does not always operate in rated operating condition, and its operating condition changes frequently in actual use. In addition, the lubrication status of piston ring is generally assumed as the flooded lubrication or a certain form of poor lubrication in most of the lubrication analysis.

In this paper, based on the equations about the flow rate of lubricating oil and the variation of control volume, the flow model of lubricating oil in the piston ring-cylinder liner conjunction is established. The lubrication analysis of piston ring for a four-stroke engine under different engine operating conditions is done, in which the lubricating oil at the inlet of piston ring is considered as the lubricating oil attached on the relevant location of cylinder wall after the piston ring moves over at the previous stroke.

There is remarkable difference for the lubrication characteristics of the piston ring under different engine operating conditions. The worst lubrication status of piston ring may not take place under engine rated operating condition.

In this paper, based on the measured engine cylinder pressure, the lubrication analysis of piston ring for a four-stroke engine under different engine operating conditions is done in which the lubricating oil supply condition at the inlet of piston ring is considered. The results of this paper are helpful for the design and research of engine piston ring-cylinder liner conjunction.

When fast fashion brands launch corporate social responsibility (CSR) programs, consumers may consider these brands to behave hypocritically as their business model is generally perceived as being inconsistent with sustainable practices. Built on construal level theory (CLT), this study aims to examine how the benefit appeals that are widely used in CSR initiatives affect perceived corporate hypocrisy and the CSR performance of fast fashion brands.

This study designed an online experiment with a 2 (fashion brand: fast fashion vs. unknown) × 2 (benefit appeal: self-benefit vs other-benefit) stimulus, using a virtual label named “Eco Care” for experimental manipulation. A total number of 298 Chinese consumers participated in the experiment and they answered an online survey.

It was found that the brand types (fast fashion vs unknown) and benefit appeals (self-benefit vs other benefit) did not elicit perceived corporate hypocrisy nor did them directly affect perceptions of CSR performance. However, there was a significant interaction effect of them. That is, fast fashion brand’s CSR performance was judged based on how the brand framed its sustainability claims. A fast fashion brand’s CSR label significantly increased hypocrisy perceptions when the label used a self-benefit appeal and the interactive effect of the fast fashion brand and the self-benefit appeal hindered the formation of a green brand image and brand purchase intentions.

This study adds a body of knowledge to the literature by examining the relationship between benefit appeals and perceived corporate hypocrisy from the perspective of CLT. The findings can help fast fashion marketers better understand the critical role of benefit appeals by acknowledging that the misuse of communication strategies may result in unfavorable consequences, thus ruining their efforts to improve their brand’s image.

This study aims to investigate the relationship between entrepreneurship and innovation efficiency (IE), as well as the moderating role of absorptive capacity.

This study uses a sample of industrial enterprises from Chinese provinces from 2005 to 2016, and it tests the research questions using the method of stochastic frontier analysis.

The results of this study indicate that entrepreneurship promotes IE, and that absorptive capacity plays a positive moderating role. In addition, the effect of entrepreneurship on IE differs between the central and eastern regions and the western region.

This research provides direct policy implications by demonstrating the role of entrepreneurship and absorptive capacity in IE, thereby guiding corporate management practices and the formulation of government innovation and entrepreneurship policies.

Current lubrication analyses of misaligned journal bearings were generally performed under some given preconditions. To make the lubrication analysis closer to the actual situation and usable to the journal bearing design, the purpose of this paper was to calculate the lubrication characteristics of misaligned journal bearings considering the viscosity-pressure effect of the oil, the surface roughness and the elastic deformation of the journal bearing at the same time.

The lubrication of bearings was analyzed using the average Reynolds equation. The deformation of the bearing surface under oil film pressure was calculated by a compliance matrix method. The compliance matrix was established by finite element analysis of the bearing housing. The viscosity-pressure and viscosity–temperature equations were used in the analysis.

The oil viscosity-pressure relationship has a significant effect on the lubrication of misaligned journal bearings. The surface roughness will affect the lubrication of misaligned journal bearings when the eccentricity ratio and angle of journal misalignment are all large. The directional parameter of the surface has an obvious effect on the lubrication of misaligned journal bearings. The deformation of the bearing surface has a remarkable effect on the lubrication of misaligned journal bearings.

The lubrication characteristics of misaligned journal bearings were calculated considering the viscosity-pressure effect of the oil, the surface roughness and the elastic deformation of the journal bearing at the same time. The results of this paper are helpful to the design of the bearing.

Chinese agri‐food chains consist of the millions of small scale farmers, who are not well structured and organized in the supply chain. Owing to market liberalization and globalization, one of the most challenging issues along agri‐food chains in China is becoming the issue of how to link these small‐scale farmers into the modern chains. Consequently, it is essential for both policy makers and private sectors to understand the governance structure in agri‐food supply chains. Therefore, the purpose of this paper is to develop a theoretical framework for supply chain governance, including its antecedents and consequences, as well as a series of hypotheses for empirical testing.

A conceptual framework of chain governance is proposed in this study, where governance structure consists of two dimensions: contractual governance and relational governance. The study intends to propose a complementary relationship between contracts and relational aspects, such as trust, in the Chinese context. Future research is needed to empirically test this model.

The proposed conceptual model is unique, since the majority of the articles addressing this topic focuses on contract farming while limited research touches upon the issues of trust and relations. However, a combination of both contracting and relationships are seldom addressed.

This paper evaluates a novel concept of two dimensional governance structure in the agri‐food supply chain, where transaction cost economics theory and relational theory are combined to study the governance relationships between small scale producers in China and their buyers.

This paper aims to examine the relationships between the group affiliates’ dual legitimacy (membership legitimacy and societal legitimacy) and dual resource acquisition (intra-group and out-group), and the moderating roles of environmental uncertainty and munificence in the emerging economies.

This paper adopts hierarchical regression analysis to test the hypotheses based on the unique data of 251 group affiliated firms in China and applies the alternative measurements and alternative methodology of structural equation modeling into robustness check to confirm the results.

The results show as follows: the group affiliates can benefit from membership legitimacy for intra-group resource acquisition and out-group resource acquisition through the mediations of societal legitimacy and intra-group resource acquisition. However, in the linkage between affiliates’ membership legitimacy and intra-group resource acquisition and the linkage between societal legitimacy and out-group resource acquisition, environmental uncertainty plays the positive moderating roles while environmental munificence plays the negative moderating roles. Under the condition of high environmental uncertainty and low environmental munificence, the linkage between membership legitimacy and intra-group resource acquisition, and the linkage between societal legitimacy and out-group resource acquisition reach the strongest level.

The findings highlight the importance of dual legitimacy building for group affiliates to acquire resources both inside and outside the business group when they operate in emerging economies characterized by high environmental uncertainty and low environmental munificence. However, it does not explore the contextual factors (e.g. institutional distance) affecting the relationship between the affiliate’s membership legitimacy and societal legitimacy. Then more group-level factors are expected to be included and explored with multi-level models in the future studies.

The findings reveal the mechanism of how group affiliates benefiting differently from dual legitimacy to acquire resources in the emerging economies, which also provide a new interpretation for the questions of who benefiting more from the group affiliation, how and why (Carney et al., 2009). This research also explores the moderating roles of task environmental characteristics (environmental uncertainty and environmental munificence) on the affiliate's dual legitimacy and dual resource acquisition, which helps understand why legitimacy building is more important in terms of resource acquisition in the emerging economy characterized by uncertainty and non-munificence.

As the US-China conflict intensifies, the United States is pursuing a ‘decoupling’ strategy to build a new world trade order, arguing that the current World Trade Organization (WTO) system does not properly regulate China's non-market economic system. The WTO provides special and differentiated treatment (S&DT) for developing countries. The United States argues that China should give up its developing country (DC) status. Sufficient research on the DC status and S&DT has not been conducted as a means of resolving the US-China conflict. Decoupling means the collapse of the global supply chain (GSC), which will bring substantial shock to the global economy and a catastrophe for China. This paper examines the re-classification of DC status and S&DT in the context of US-China conflict and seeks an approach for China to avoid decoupling and coexist with the United States. It would be an optimal way for China to revive the WTO first and to improve its economic system through negotiations under the WTO.