Search results

Large structural objects, primarily concrete bridges, can be reinforced by gluing to their stretched surface tapes of fiber-reinforced polymer (FRP). The condition for this technology to work requires the quality of the bonding of FRP and the concrete to be perfect. Possible defects may arise in the phase of construction but also as a result of long-term fatigue loads. These defects having different forms of voids and discontinuities in the bonding layer are difficult to detect by optical inspection. This paper aims to describe the development of a rapid and nondestructive method for quantitative assessment of the debonding between materials.

The applied technique belongs to the wide class of active infrared (IR) thermography, the principle of which is to heat (or cool) the investigated object, and determine the properties of interest from the recorded, by an IR camera, temperature field. The methodology implemented in this work is to uniformly heat for a few seconds, using a set of halogen lamps, the FRP surface attached to the concrete. The parameter of interest is the thermal resistance of the layer separating the polymer tape and the concrete. The presence of voids and debonding will result in large values of this resistance. Its value is retrieved by solving an inverse transient heat conduction problem. This is accomplished by minimizing, in the sense of least squares, the difference between the recorded and simulated temperatures. The latter is defined as a solution of a 1D transient heat conduction problem with the already mentioned thermal resistance treated as the only decision variable.

A general method has been developed, which detects debonding of the FRP tapes from the concrete. The method is rapid and nondestructive. Owing to a special selection of the compared dimensionless measured and simulated temperatures, the method is not sensitive to the surface quality (roughness and emissivity). Measurements and calculation may be executed within seconds. The efficiency of the technique has been shown at a sample, where the defects have been artificially introduced in a controlled manner.

A quantitative assessment procedure which can be used to determine the extent of the debonding has been developed. The procedure uses inverse technique whose result is the unknown thermal resistance between the member and the FRP strip.

The internal combustion engine operated on gaseous fuels shows great potential in terms of integration of the renewable and traditional sources for an effective solution for clean energy production challenge. Different fuel mixtures that can be used to power the engine are characterized by various combustion properties, which can affect its overall efficiency. The purpose of this paper is to provide reasonable answer, how the operation condition can change due to different fuel, without enormous cost of prototyping processes using physical models a digital model can be seen as promising technique.

Presented work discusses the application, and extensive description of two commercial codes Ansys Fluent and Forte for modeling stationary engine fueled by compressed natural gas (CNG) and biogas. To check the model accuracy, all carried out numerical results were compared against experimental data collected at in-house test rig of single cylinder four stroke engine. The impacts of tested gaseous fuel on the engine working conditions and emission levels were investigated.

Carried out simulations showed good agreement with experimental data for investigated cases. Application on numerical models give possibility to visualize flame front propagation and pollutant formation for tested fuels. The biogas fuel has shown the impaired early flame phase, which led to longer combustion, lower efficiency, power output, repeatability and in some cases higher HC and carbon monoxide (CO) emissions as a result of combustion during the exhaust stroke. Looking at the CO formation it was observed that it instantly accrue with flame front propagation as a result of methane oxidation, while for NOx formation revers effect was seen.

The application of new approach for modeling combustion process in stationary engines fueled by CNG and alternative biogas fuel has been discussed. The cons and pros of the Forte code in terms of its application for engine prototaping process has been discussed.