Search results

The purpose of this paper is to present and discuss the results of measurements illustrating influence of the area of a thermal pad and the kind of the used base on thermal and optical parameters of LED modules.

LED modules including six power LEDs are designed. In the layout of these modules, different areas of a thermal pad of each LED are used. These modules are made using the classical FR-4 base and metal core printed circuit board (MCPCB). Thermal and optical parameters of all the tested modules are measured using the method elaborated by the authors.

The obtained results of measurements prove that increasing the area of a thermal pad causes a decrease in thermal resistance of the tested LED modules and an increase in power density of the emitted light. The role of the area of a thermal pad is more important for the classical FR-4 base than for MCPCB.

Investigations were performed for only two values of the area of thermal pads and selected values of LEDs forward current.

The presented results of investigations show how the used layout and type of the used base of these modules influence optical and thermal parameters of LED modules. Changing the base of a module can cause even a double decrease in thermal resistance and a double increase in power density of the emitted light.

This paper aims to present the results of investigations that show the influence of ZnO composite soldering paste on the optical and thermal parameters of power light-emitting diodes (LEDs).

ZnO nanocomposite solder alloys were produced via the ball milling process from the solder paste Sn99Ag0.3Cu0.7 (SACX0307) and 1.0 wt% of ZnO nanoparticle reinforcements with different primary particle sizes (200 nm, 100 nm and 50 nm). Power LEDs were soldered onto a metal core printed circuit board. A self-designed LED test system was used to measure the thermal and optical characteristics of the LEDs.

The influence of the soldering paste on the thermal and optical parameters of LEDs was observed. In all solder alloys, ZnO ceramic reinforcement, at a level of 1 wt%, increased the thermal parameters of LEDs and decreased their luminous efficiency. Thermal resistance values were10% higher, and junction temperature change over ambient temperature was 20% higher for the samples soldered with composite solder pastes than the reference sample. At the same time, luminous efficiency dropped by 32%.

The results prove that ZnO ceramic reinforcement of solder paste influences the thermal properties of solder joints. As was proven, the quality of the solder joints influences the whole assembly.