To read this content please select one of the options below:

New technologies of multi-layered printed circuit boards, intended of rapid-design electronic modules

Wojciech Stęplewski (Centre for Advanced Technology, Tele and Radio Research Institute, Warsaw, Poland)
Mateusz Mroczkowski (Astri Polska Sp. z o. o., Warsaw, Poland)
Radoslav Darakchiev (Astri Polska Sp. z o. o., Warsaw, Poland)
Konrad Futera (Centre for Advanced Technology, Tele and Radio Research Institute, Warsaw, Poland)
Grażyna Kozioł (Centre for Advanced Technology, Tele and Radio Research Institute, Warsaw, Poland)

Circuit World

ISSN: 0305-6120

Article publication date: 3 August 2015

185

Abstract

Purpose

The purpose of this study was the use of embedded components technology and innovative concepts of the printed circuit board (PCB) for electronic modules containing field-programmable gate array (FPGA) devices with a large number of pins (e.g. Virtex 6, FF1156/RF1156 package, 1,156 pins).

Design/methodology/approach

In the multi-layered boards, embedded passive components that support FPGA device input/output (I/O), such as blocking capacitors and pull-up resistors, were used. These modules can be used in rapid design of electronic devices. In the study, the MC16T FaradFlex material was used for the inner capacitive layer. The Ohmega-Ply RCM 25 Ω/sq material was used to manufacture pull-up resistors for high-frequency pins. The embedded components have been connected to pins of the FPGA component by using plated-through holes for capacitors and blind vias for resistors. Also, a technique for a board-to-board joining, by using castellated terminations, is described.

Findings

The fully functional modules for assembly of the FPGA were manufactured. Achieved resistance of embedded micro resistors, as small as the smallest currently used surface-mount device components (01005), was below required tolerance of 10 per cent. Obtained tolerance of capacitors was less than 3 per cent. Use of embedded components allowed to replace the pull-up resistors and blocking capacitors and shortens the signal path from the I/O of the FPGA. Correct connection to the castellated terminations with a very small pitch was also obtained. This allows in further planned studies to create a full signal distribution system from the FPGA without the use of unreliable plug connectors in aviation and space technology.

Originality/value

This study developed and manufactured several innovative concepts of signal distribution from printed circuit boards. The signal distribution solutions were integrated with embedded components, which allowed for significant reduction in the signal path. This study allows us to build the target object that is the module for rapid design of the FPGA device. Usage of a pre-designed module would lessen the time needed to develop a FPGA-based device, as a significant part of the necessary work (mainly designing the signal and power fan-out) will already be done during the module development.

Keywords

Citation

Stęplewski, W., Mroczkowski, M., Darakchiev, R., Futera, K. and Kozioł, G. (2015), "New technologies of multi-layered printed circuit boards, intended of rapid-design electronic modules", Circuit World, Vol. 41 No. 3, pp. 121-124. https://doi.org/10.1108/CW-03-2015-0008

Publisher

:

Emerald Group Publishing Limited

Copyright © 2015, Emerald Group Publishing Limited

Related articles