Search results

The purpose of this study is to investigate the deformation characteristics and failure modes of the right bank slope of Xiluodu Hydropower Station after excavation.

Micro-seismic monitoring technology is applied to obtain the microfracture information and study the internal damage evolution law of the slope rock mass. A numerical model for discontinuous deformation analysis (DDA) is established to analyse the deformation characteristics and failure mode of the slope. Micro-seismic monitoring and DDA can verify and supplement each other's results in the investigation of slope failure.

The results show that the slope has a downhill displacement along the weathered zone under natural conditions; the maximum resultant displacement at the monitoring point is 380 mm. The micro-seismic events are concentrated in an area located 30–100 m horizontally away from the slope surface and at an elevation of 390–470 m. The distribution of these micro-seismic events is consistent with the location of the unloading and weathered zones; it is the same as the DDA simulation result.

The study is anticipated to be used as reference for the stability analysis of rock slopes. By combining the continuous (micro-seismic monitoring technology) and discontinuous (DDA) methods, the entire process starting from the gradual accumulation of internal rock micro-damage to the macroscopic discontinuous deformation and failure of the slope can be investigated.

This paper describes the use of fibre‐optics for seismic monitoring in oil wells. Based on fibre Bragg grating technology, the system can withstand temperatures of up to 175°C and extremely high pressures. It allows seismic surveys to be undertaken throughout the lifetime of the well.

The purpose of this paper is to investigate the anisotropic characteristics of the special structure of a columnar jointed rock masses and provide reference to forecast the behavioral characteristics of real samples.

This study used FLAC3D numerical software to simulate the mechanical behavior of columnar jointed rock masses with different columns angles (ß) under different stress conditions. The peak strength, elastic modulus and Poisson’s ratio were obtained to investigate the strength, deformation characteristics and failure modes of the rock masses under conventional and true triaxial compression.

The results showed that the compressive strength of the specimens presents a U-shape under different joint inclinations. The strength of the specimens reaches a maximum value when ß = 90°, and the value for ß = 0° is slightly lower and reaches a minimum value when ß = 50°. The elastic modulus and Poisson’s ratio of the samples are obviously anisotropic, the anisotropic coefficient decreases with increasing confining pressure. When σ₂ ≠ σ₃, the peak strengths of the samples are related to the direction of the minor principal stress, and the failure modes of the samples are related to the confining pressure and joint inclination.

The present paper uses a numerical simulation method to examine the strength and deformation characteristics of a columnar jointed rock mass under conventional and true triaxial compression. The aim is to provide a reference to forecast the mechanical characteristics of test samples in the laboratory.