Search results

This paper aims to propose a structural sizing approach of an unmanned aerial vehicle (UAV) wing that takes into account the aeroelasticity effects through a fluid–structure interaction analysis.

The sizing approach proposed in this study is an iterative process, each iteration of which consists of two sub-loops, a multidisciplinary analysis (MDA) loop followed by a structural optimization loop. The MDA loop seeks the aeroelastic equilibrium between aerodynamic forces and structural displacements using a fixed-point iteration scheme. Once the equilibrium is reached, the converged pressure loads are used for the structural optimization, which aims to find the structural thicknesses that minimize the wing weight under failure criteria. The two sub-loops are run sequentially in an iterative process until the mass is converged. The analysis models are implemented in open-source software, namely, PANUKL for aerodynamics and MYSTRAN for structures, while the whole process is automated with Python and integrated in the open-source optimization framework OpenMDAO.

The approach was applied to the design of the Predator MQ-1 wing. The results of the MDAs show the convergence of the wing deformations to the flight shape after few iterations. At the end of the aeroelastic sizing loop, the result is a structurally sized wing with minimal weight considering the aeroelasticity effects.

The approach proposed takes into account the wing aero-structural coupling effects while sizing its structure instead of a fixed load distribution. In addition, the approach is fully based on open-source codes, which are freely available for public use and can be fully reproducible.

This paper aims to assess the feasibility of additively manufactured wind tunnel models. The additively manufactured model was used to validate a computational framework allowing the evaluation of the performance of five wing models.

An optimized fighter wing was additively manufactured and tested in a low-speed wind tunnel to obtain the aerodynamic coefficients and deflections at different speeds and angles of attack. The flexible wing model with optimized curvilinear spars and ribs was used to validate a finite element framework that was used to study the aeroelastic performance of five wing models. As a computationally efficient optimization method, homogenization-based topology optimization was used to generate four different lattice internal structures for the wing in this study. The efficiency of the spline-based optimization used for the spar-rib model and the lattice-based optimization used for the other four wings were compared.

The aerodynamic loads and displacements obtained experimentally and computationally were in good agreement, proving that additive manufacture can be used to create complex accurate models. The study also shows the efficiency of the homogenization-based topology optimization framework in generating designs with superior stiffness.

To the best of the authors’ knowledge, this is the first time a wing model with curvilinear spars and ribs was additively manufactured as a single piece and tested in a wind tunnel. This research also demonstrates the efficiency of homogenization-based topology optimization in generating enhanced models of different complexity.