Multitest leverages MT9510×16 for quad-site MEMS applications

Citation

(2012), "Multitest leverages MT9510×16 for quad-site MEMS applications", Microelectronics International, Vol. 29 No. 3. https://doi.org/10.1108/mi.2012.21829cab.011

Multitest leverages MT9510×16 for quad-site MEMS applications

Article Type: New products From: Microelectronics International, Volume 29, Issue 3

Multitest has expanded its MEMS portfolio to pick-and-place applications with the introduction of its test and calibration cart for the MT9510. Multitest MEMS solutions now are available for strip test and singulated package test – on Multitest InStrip^® with optional InCarrier™, the well-established gravity test handlers MT93xx and MT9928, or the MT9510XP tri-temp pick-and-place handler.

This new combination is based on the two well-established platforms: MT MEMS and MT9510. This setup leverages Multitest’s long-term MEMS test expertise as well as thorough understanding of the challenges in DUT handling. Thus, the industry-leading positioning accuracy and tri-temp performance of the MT9510 also is now available for MEMS test.

Multitest has developed this even further by leveraging the contact site dimension of the MT9510×16. The company now is able to offer a quad-site test solution for MEMS on pick-and-place handlers. Based on the same MEMS cart as for the MT9928, this MT9510×16/MEMS setup uses both Multitest’s pick-and-place and MEMS expertise.

For more information, visit: www.multitest.com/MEMS or www.multitest.com/MT9510x16; www.multitest.com