A hybrid approach for machining optimization of the WEDM using grey-fuzzy with Metaphor-Less algorithms for Ti-3Al-2.5V

Abstract

Purpose

This paper aims to investigate the influence of “BroncoCut-X” (copper core-ZnCu50 coating) electrode on the machining of Ti-3Al-2.5V in view of its extensive use in aerospace and medical applications. The machining parameters are selected as Spark-off Time (ST_off), Spark-on Time (ST_on), Wire-speed (S_w), Wire-Tension (WT) and Servo-Voltage (S_v) to explore the machining outcomes. The response characteristics are measured in terms of material removal rate (MRR), average kerf width (KW) and average-surface roughness (SA).

Design/methodology/approach

Taguchi’s approach is used to design the experiment. The “AC Progress V2 high precision CNC-WEDM” is used to conduct the experiments with ϕ 0.25 mm diameter wire electrode. The machining performance characteristics are examined using main effect plots and analysis of variance. The grey-relation analysis and fuzzy interference system techniques have been developed to combine (called grey-fuzzy reasoning grade) the experimental response while Rao-Algorithm is used to calculate the optimal performance.

Findings

The hybrid optimization result is obtained as ST_off = 50µs, ST_on = 105µs, S_w = 7 m/min, WT = 12N and S_v=20V. Additionally, the result is compared with the firefly algorithm and improved gray-wolf optimizer to check the efficacy of the intended approach. The confirmatory test has been further conducted to verify optimization results and recorded 8.14% overall machinability enhancement. Moreover, the scanning electron microscopy analysis further demonstrated effectiveness in the WEDMed surface with a maximum 4.32 µm recast layer.

Originality/value

The adopted methodology helped to attain the highest machinability level. To the best of the authors’ knowledge, this work is the first investigation within the considered parametric range and adopted optimization technique for Ti-3Al-2.5V using the wire-electro discharge machining.

Citation

Kumar, A., Upadhyay, C., Subbiah, R. and Nagaraju, D.S. (2024), "A hybrid approach for machining optimization of the WEDM using grey-fuzzy with Metaphor-Less algorithms for Ti-3Al-2.5V", World Journal of Engineering, Vol. 21 No. 5, pp. 894-910. https://doi.org/10.1108/WJE-01-2023-0006