Study on laser sintering of pine/co-PES composites and the investment casting process

Abstract

Purpose

A pine/co-PES composite (PCPES composite) was proposed as the feedstock for powder bed fusion (laser sintering, LS). This paper aims to provide some necessary experimental data and the theoretical foundation for LS of pine/co-PES, especially for the application of using the laser-sintered pine/co-PES parts as complex structural patterns in investment casting.

Design/methodology/approach

The PCPES composites with different pine loadings were mixed mechanically. The composite’s preheating temperature and processing temperature during LS were determined experimentally based on the material’s thermal behavior. The effects of pine powder on the binding mechanism of PCPES composites were discussed through analyzing the microstructure of the laser-sintered parts’. Mechanical properties and dimensional precision of laser-sintered PCPES parts in different pine loadings were tested, and the parts’ mechanical properties were strengthened by wax-infiltration post-processing. The influence extents of process parameters on the mechanical properties of laser-sintered 20 Wt.% pine/co-PES parts were investigated using a 1/2 fractional factorials experiment.

Findings

20 Wt.% pine/co-PES is considered to be a promising wood-plastic composite for laser sintering. The relationship between mechanical strength of its laser-sintered parts and process parameters was built up using mathematical formulas. Experimental results show density, tensile strength, flexural strength and surface roughness of laser-sintered 20 Wt.% pine/co-PES parts are improved by 72.7-75.0%, 21.9-111.3%, 26.8-86.2%, 27.0-29.1% after post-process infiltration with a wax. A promising application of the wax-infiltrated laser-sintered parts is for investment casting cores and patterns.

Research limitations/implications

The proper process parameters and forming properties of laser-sintered parts are limited to the results of laser sintering experiments carried on using AFS 360 rapid prototyping device.

Originality/value

This investigation not only provides a new feedstock for laser sintering with the advantages of low cost and fabricability but also uses an advanced technique to produce personalized wood-plastic parts efficiently. Mathematical models between mechanical properties of laser-sintered PCPES parts and LS process parameters will guide the further LS experiments using the 20 Wt.% pine/co-PES composite. Besides, the laser-sintered PCPES parts after wax-infiltration post-processing are promising as complex structural patterns for use in investment casting.

Citation

Zhang, H., Bourell, D., Guo, Y., Zhang, X., Zhuang, Y., Yu, Y., Jiang, K. and Helal, W.M.K. (2019), "Study on laser sintering of pine/co-PES composites and the investment casting process", Rapid Prototyping Journal, Vol. 25 No. 8, pp. 1349-1358. https://doi.org/10.1108/RPJ-01-2019-0019