To read this content please select one of the options below:

Fe3O4@SiO2 magnetic nanocomposites as adsorbents for removal of diazinon from aqueous solution: isotherm and kinetic study

Zahra Shamsizadeh (Department of Environmental Health Engineering, Environmental Science and Technology Research Center, Shahid Sadoughi University of Medical Sciences, Yazd, Iran)
Mohammad Hassan Ehrampoush (Department of Environmental Health Engineering, Environmental Science and Technology Research Center, Shahid Sadoughi University of Medical Sciences, Yazd, Iran)
Zahra Dehghani Firouzabadi (Department of Environmental Health Engineering, Environmental Science and Technology Research Center, Shahid Sadoughi University of Medical Sciences, Yazd, Iran)
Tahereh Jasemi Zad (Department of Environmental Health Engineering, Environmental Science and Technology Research Center, Shahid Sadoughi University of Medical Sciences, Yazd, Iran)
Fereshteh Molavi (Department of Environmental Health Engineering, Environmental Science and Technology Research Center, Shahid Sadoughi University of Medical Sciences, Yazd, Iran)
Ali Asghar Ebrahimi (Department of Environmental Health Engineering, Environmental Science and Technology Research Center, Shahid Sadoughi University of Medical Sciences, Yazd, Iran)
Mohammad Kamranifar (Department of Environmental Health Engineering, Social Determinants of Health Research Center, Faculty of Health, Birjand University of Medical Sciences, Birjand (BUMS), Iran)

Pigment & Resin Technology

ISSN: 0369-9420

Article publication date: 9 July 2020

Issue publication date: 19 October 2020

188

Abstract

Purpose

The purpose of this study was to the synthesis of Fe3O4@SiO2 nanocomposites and using it as an adsorbent for removal of diazinon from aqueous solutions. Structural characteristics of the synthesized magnetic nanocomposite were described by Fourier transform infrared spectroscopy and scanning electron microscopy.

Design/methodology/approach

The effects of different parameters including pH (2-10), contact time (1-180 min), adsorbent dosage (100-2000 mg L−1) and initial diazinon concentration (0.5–20 mg L−1) on the removal processes were studied. Finally, isotherm and kinetic and of adsorption process of diazinon onto Fe3O4@SiO2 nanocomposites were investigated.

Findings

The maximum removal efficiency of diazinon (96%) was found at 180 min with 1000 mg L−1 adsorbent dosage using 0.5 mg L−1 diazinon concentration at pH = 7. The experimental results revealed that data were best fit with the pseudo-second-order kinetic model (R2 = 0.971) and the adsorption capacity was 10.90 mg g−1. The adsorption isotherm was accordant to Langmuir isotherm.

Originality/value

In the present study, the magnetic nanocomposites were synthesized and used as an absorbent for the removal of diazinon. The developed method had advantages such as the good ability of Fe3O4@SiO2 nanocomposites to remove diazinon from aqueous solution and the magnetic separation of this absorbent that make it recoverable nanocomposite. The other advantages of these nanocomposites are rapidity, simplicity and relatively low cost.

Keywords

Acknowledgements

The authors express their gratitude to colleagues at the Environmental Science and Technology Research Center of Shahid Sadoughi University of Medical Sciences (Iran) for providing the technical and financial support.

Citation

Shamsizadeh, Z., Ehrampoush, M.H., Dehghani Firouzabadi, Z., Jasemi Zad, T., Molavi, F., Ebrahimi, A.A. and Kamranifar, M. (2020), "Fe3O4@SiO2 magnetic nanocomposites as adsorbents for removal of diazinon from aqueous solution: isotherm and kinetic study", Pigment & Resin Technology, Vol. 49 No. 6, pp. 457-464. https://doi.org/10.1108/PRT-02-2020-0010

Publisher

:

Emerald Publishing Limited

Copyright © 2020, Emerald Publishing Limited

Related articles