Search results

The limited supply of fossil fuels, constant rise in the demand of energy and the importance of reducing greenhouse emissions have brought the adoption of renewable energy sources for generation of electrical power. One of these sources that has the potential to supply the world’s energy needs is the ocean. Currently, ocean in West African region is mostly utilized for the extraction of oil and gas from the continental shelf. However, this resource is depleting, and the adaptation of ocean energy could be of major importance. The purpose of this paper is to discuss the possibilities of ocean-based renewable energy (OBRE) and analyze the economic impact of adapting an ocean energy using a thermal gradient (OTEC) approach for energy generation.

The analysis is conducted from the perspective of cost, energy security and environmental protection.

This study shows that adapting ocean energy in the West Africa region can significantly produce the energy needed to match the rising energy demands for sustainable development of Nigeria. Although the transition toward using OBRE will incur high capital cost at the initial stage, eventually, it will lead to a cost-effective generation, transmission, environmental improvement and stable energy supply to match demand when compared with the conventional mode of generation in West Africa.

This study will be helpful in determining the feasibility, performance, issues and environmental effects related to the generation and transmission of OBRE in the West Africa region.

The study will contribute toward analysis of the opportunities for adopting renewable energy sources and increasing energy sustainability for the West Africa coast regions.

The purpose of this paper is to investigate the influence of geometrical microstructure of items obtained by applying a three-dimensional (3D) printing technology on their mechanical strength.

Three-dimensional printed items (3DPI) are composite structures of complex internal constitution. The buildup of the finite element (FE) computational models of 3DPI is based on a multi-scale approach. At the micro-scale, the FE models of representative volume elements corresponding to different additive layer heights and different thicknesses of extruded fibers are investigated to obtain the equivalent non-linear nominal stress–strain curves. The obtained results are used for the creation of macro-scale FE models, which enable to simulate the overall structural response of 3D printed samples subjected to tensile and bending loads.

The validation of the models was performed by comparing the computed results against the experimental ones, where satisfactory agreement has been demonstrated within a marked range of thicknesses of additive layers. Certain inadequacies between computed against experimental results were observed in cases of thinnest and thickest additive layers. The principle explanation of the reasons of inadequacies takes into account the poorer quality of mutual adhesion in case of very thin extruded fibers and too-early solidification effect.

Flexural and tensile experiments are simulated by FE models that are created with consideration to microstructure of 3D printed samples.