Blowholing in PTH Solder Fillets: Part 2 The Nature, Origin and Evolution of the Gas

Abstract

This paper is the second of a series dealing with the blowholing problem on through‐hole plated printed circuit boards. In the previous paper the authors have considered the impact of the problem on the UK electronics assembly industry. Here they consider the nature of the gas causing blowholes and voids, its origin and the kinetics of its generation and evolution. When a printed circuit board with plated‐through‐holes is wave soldered, the thermal spike of the molten solder activates the evolution of gas, sometimes in relatively enormous quantities. The gas is seen bubbling from the surface of the molten solder in the joint. Upon freezing, the solder either traps the gas in a void enclosed within the fillet or, if the gas is escaping from the surface as freezing occurs, forms a blowhole.

Citation

Howie, F.H. and Lea, C. (1986), "Blowholing in PTH Solder Fillets: Part 2 The Nature, Origin and Evolution of the Gas", Circuit World, Vol. 12 No. 4, pp. 20-25. https://doi.org/10.1108/eb043832