To read the full version of this content please select one of the options below:

Standardization of Aero‐Engine Components

G. Carvelli (Wright Aeronautical Corporation)

Aircraft Engineering and Aerospace Technology

ISSN: 0002-2667

Article publication date: 1 January 1943

Abstract

STANDARDIZATION of engine components should start in the drawing office. To ensure uniformity in regard to method of dimensioning and standardization of data and notes, a system of sample drawing may be used. For example, if a drawing is to be made of a connecting rod, crankshaft, piston, piston ring, and so on, the draughtsman should refer to a list showing the sample drawing number for each particular part. The drawing may be obtained from file and used as a guide in producing the drawing. Fig. 1 shows one of these lists. To guide the draughtsman in selecting the proper sample drawing, a remarks column is used with a description oi the part.

Citation

Carvelli, G. (1943), "Standardization of Aero‐Engine Components", Aircraft Engineering and Aerospace Technology, Vol. 15 No. 1, pp. 23-28. https://doi.org/10.1108/eb030983

Publisher

:

MCB UP Ltd

Copyright © 1943, MCB UP Limited