To read this content please select one of the options below:

Modeling of Ca/P and deposit size responses of electrodeposited calcium-phosphate coating using full factorial design

Mohabbat Amirnejad (Babol Noshirvani University of Technology, Babol, Iran)
Mohammad Rajabi (Babol Noshirvani University of Technology, Babol, Iran)
Roohollah Jamaati (Babol Noshirvani University of Technology, Babol, Iran)

Engineering Computations

ISSN: 0264-4401

Article publication date: 2 November 2023

Issue publication date: 5 December 2023

22

Abstract

Purpose

This study aims to investigate the effect of electrodeposition parameters (i.e. time and voltage) on the properties of hydroxyapatite (HA) coating fabricated on Ti6Al4V surface.

Design/methodology/approach

A full factorial design along with response surface methodology was utilized to evaluate the main effect of independent variables and their relative interactions on response variables. The effect of electrodeposition voltage and deposition time on HA coatings Ca/P molar ratio and the size of deposited HA crystals were examined by structural equation modeling (SEM). The formation of plate-like and needle-like HA crystals was observed for all experiments.

Findings

The results obtained showed that the higher electrodeposition voltage leads to lower Ca/P values for HA coatings. This is more significant at lower deposition times, where at a 20-minute deposition time, the voltage increased from 2 to 3 V and the Ca/P decreased from 2.27 to 1.52. Full factorial design results showed that electrodeposition voltage has a more significant effect on the size of the deposited HA crystal. With increasing the voltage from 2 to 3 V at a deposition time of 20 min, the HA crystal size varied from 99 to 36 µm.

Originality/value

The investigation delved into the impact of two critical parameters, deposition time and voltage, within the electrodeposition process on two paramount properties of HA coatings. Analyzing the alterations in coating characteristics relative to variations in these process parameters can serve as a foundational guide for subsequent research in the domain of calcium-phosphate deposition for implants.

Keywords

Citation

Amirnejad, M., Rajabi, M. and Jamaati, R. (2023), "Modeling of Ca/P and deposit size responses of electrodeposited calcium-phosphate coating using full factorial design", Engineering Computations, Vol. 40 No. 9/10, pp. 2794-2813. https://doi.org/10.1108/EC-02-2023-0087

Publisher

:

Emerald Publishing Limited

Copyright © 2023, Emerald Publishing Limited

Related articles