Investigation of mechanical and corrosion behavior of laser hybrid weld joint of 2205 duplex stainless steel

Abstract

Purpose

Duplex stainless steel is composed of equal amounts of austenite and ferrite, which has excellent corrosion resistance and strength. However, after the metal was welded, the ratio of austenite and ferrite in the joint is unbalanced, and secondary phase precipitates are produced, which is also an important cause of pitting corrosion in the joint.

Design/methodology/approach

This paper aims to study the mechanical and corrosion behavior of welded joints, by adjusting the welding parameters of laser hybrid welding, dual heat sources are used to weld 2205 duplex stainless steel. The two-phase content of different parts of the welded joint is measured to study the influence of the ratio of the two-phase on the mechanical and corrosion properties of the joint.

Findings

The ratio of austenite and ferrite in different welded joints has an obvious difference, and from top to bottom, the austenite content decreased gradually, and the ferrite content increased gradually. The harmful phases are precipitated in the middle and lower part of the joint. The strength of welded joints is slightly lower than that of base metal. At the same time, the fracture analysis shows that some ferrite phases are affected by the precipitate in the grain and produce quasi-cleavage fracture. The corrosion results show that the corrosion resistance of the welded joints is lower than that of the base metal, and the concentration of chloride ions affects the corrosion resistance.

Originality/value

In this paper, the authors use the influence of different welding processes on the two-phase ratio of the joint to further study the influence of the microstructure on the corrosion resistance and mechanical properties of the weld.

Citation

Zheng, C., Zhang, C., Wang, X.Y. and Gu, J. (2021), "Investigation of mechanical and corrosion behavior of laser hybrid weld joint of 2205 duplex stainless steel", Anti-Corrosion Methods and Materials, Vol. 68 No. 5, pp. 357-364. https://doi.org/10.1108/ACMM-03-2021-2453