Influence of spectrum loading on fatigue resistance of AA6082 friction stir welds
Abstract
Purpose
Welded components are often subjected to variable amplitude service loads, increasing the uncertainty of fatigue life due to material strength, notch geometries, defect content and residual stresses. In the case of friction stir welding (FSW) of aluminium alloys no data were found available concerning fatigue behaviour under variable amplitude loading. The purpose of this paper is to determine the fatigue strength of friction stir welds in AA6082‐T6 under constant and variable amplitude loading and analyse the validity of Miner's rule for these specific welding conditions.
Design/methodology/approach
Fatigue tests were carried out in a servo‐hydraulic testing machine using a stress ratio of R=0. Typified Gassner amplitude spectra were considered, using four shape exponent values. Microhardness tests were performed to characterize the Vickers hardness profile in the vicinity of the weld area. Relatively to the base material (BM), the FSW process leads to a decrease of the static mechanical properties.
Findings
Detailed examination revealed a hardness decrease in the thermo‐mechanically affected zone and the nugget zone average hardness was found to be lower than the base alloy hardness. The comparison with data collected from the literature shows that FSW specimens present higher fatigue resistance than specimens welded by metal inert gas and tungsten inert gas processes. However, they still have lower fatigue lives than the BM. Using the equivalent stress calculated by Miner's rule, a good agreement was observed between constant and variable fatigue loading results. The characteristic curve obtained for friction stir welds is higher than the International Institute of Welding (IIW) fatigue class for fusion welds with full‐penetration both‐sided butt joints.
Originality/value
No data are available concerning fatigue behaviour under variable amplitude loading for friction stir welds of aluminium alloys. Furthermore, this paper analyses the fatigue strength of friction stir welds in AA6082‐T6 under constant and variable amplitude loading in order to verify the validity of Miner's rule for this specific welding process. A comparison between characteristic fatigue curves, using IIW fatigue classes (FAT), is also performed.
Keywords
Citation
Costa, J.D., Ferreira, J.A.M. and Borrego, L.P. (2011), "Influence of spectrum loading on fatigue resistance of AA6082 friction stir welds", International Journal of Structural Integrity, Vol. 2 No. 2, pp. 122-134. https://doi.org/10.1108/17579861111135888
Publisher
:Emerald Group Publishing Limited
Copyright © 2011, Emerald Group Publishing Limited