Search results

Hydraulic conductivity is very low in saline-sodic soil, which decreases water infiltration. For saline-sodic soil, increasing infiltration water has a special meaning. Increasing infiltration water not only increases the water in the soil profile but also decreases the salinity of the soil, thus making it suitable for growing crops. This study aims to examine the effect of sand pipes on soil water and salt distribution through laboratory tests with different depths and diameters of sand pipes.

The soil water and salt distribution responses to different sand pipe depths and diameters was investigated. Treatments included sand pipes with diameters of 4 cm, 5cm, 6 cm and the same depth of 4 cm; with depths of 2cm, 6 cm and the same diameter of 5 cm, and a control with no sand pipe (with the diameter of 0 cm and the depth of 0 cm).

The results suggested that the amount of cumulative infiltration water and transport distance of the wetting front could be increased by increasing the depth and diameter of sand pipes. The soil water content in the soil profile decreased under all treatments except for the control, whereas the value of EC increased with increasing distance from the film hole center. Positive relationships were also found among the sand pipe depth, diameter and the zone of low salt content. Furthermore, salt leaching depth increased with sand pipe depth and diameter. Overall, the treatments with and without sand pipes exhibited obvious differences.

The correlation analysis proved that increasing the infiltration area through sand pipes positively affected the amount of infiltration water, wetting scope and salt leaching depth.

This study aims to analyze the changes in the ecosystem service value (ESV) in response to land use and contribute significantly to ecological construction and sustainable development.

The present study was conducted in the upper Zhanghe River region based on the moderate-resolution imaging spectroradiometer Land Cover Type product MCD12Q1 by using geographic information system (GIS) methods to process and re-classify the land-use data and using the Chinese ESV equivalent weight factors to investigate changes in land use and resulting changes in ESV between 2001 and 2013.

The results showed significant fluctuations in ESV between 2001 and 2013: there was a decline in ESV from 2001 to 2004, followed by a gradual rise after 2004, and the overall ESV exceeded 2001 levels by the end of 2013. However, the pattern of ESV change differed across geographic locations, and each administrative region contributed differently to the overall trend. The analysis confirmed that the land-use change was closely related to the change in its ESV, and the coefficients of sensitivity of ESV for all types of land use were less than one, indicating that the coefficient value of ESV lacked elasticity.

Therefore, to promote sustainable development in the upper Zhanghe River region, ESV should be taken into consideration when planning land use, especially for land types with high ESV, such as water bodies and forestlands.

The results can provide scientific support for the sustainable development of the ecological, economic and societal aspects of the upper Zhanghe River region. In addition, county-level administrative divisions were set as the basic research unit for the analysis and discussion of ESV changes in each unit within the research period and its impact on the overall ESV of the entire area to lay down a foundation for the analysis of the ESV spatial dynamic distribution in the entire research site.

The remote sensing data have become the irreplaceable source of data for the regions with little or without rainfall data, but these data also require scientific analysis, correction and application. This paper uses FY-2 rainfall data and the case studies of the droughts occurred in the Weihe River Basin from 2006 to 2009 to monitor the spatial and temporal evolution of climatic droughts. The monitoring results indicate that: (1) Except for 2008 which was a dry year, the other years in the Weihe River Basin had normal dry/wet conditions; (2) From October 2008 to January 2009, the rainfall was significantly reduced across the Weihe River Basin, and the continual rainfall was even less than 1 mm for December and January with a precipitation anomaly percentage lower than -80%, a sign of severe climatic drought. But the rainfall has improved since February 2009, when the precipitation reached 17.8 mm and Pa exceeded 100%, which helped to relieve the stress from drought resistance. A heavy precipitation continued for four months from June to September 2008, with the Pa exceeding 50%; (3) Due to the better temporal and spatial continuity than the ground-based meteorological observation, FY-2 precipitation data have good application prospects in the meteorological drought monitoring at a national or regional macro-scale.

The product family assembly line (PFAL) is a mixed model-assembly line, which is widely used in mass customization and intelligent manufacturing. The purpose of this paper is to study the problem of PFAL, a flexible (evolution) planning method to respond to product evolution for PFAL, to focus on product data analysis and evolution planning method.

The evolution balancing model for PFAL is established and an improved NSGA_II (INSGA_II) is proposed. From the perspective of data analysis, dynamic characteristics of PFAL are researched and analyzed. Especially the tasks, which stability is considered, can be divided into a platform and individual task. In INSGA_II algorithm, a new density selection and a decoding method based on sorting algorithms are proposed to compensate for the lack of traditional algorithms.

The effectiveness and feasibility of the method are validated by an example of PFAL evolution planning for a family of similar mechanical products. The optimized efficiency is significantly improved using INSGA_II proposed in this paper and the evolution planning model proposed has a stronger ability to respond to product evolution, which maximizes business performance over an effective period of time.

The assembly line designers and managers in discrete manufacturing companies can obtain an optimal solution for PFAL planning through the evolution planning model and INSGA-II proposed in this paper. Then, this planning model and optimization method have been successfully applied in the production of small wheel loaders.

The purpose of this paper is to find an accurate, efficient and easy-to-implement point estimate method (PEM) for the statistical moments of random systems.

First, by the theoretical and numerical analysis, the approximate reference variables for the frequently used nine types of random variables are obtained; then by combining with the dimension-reduction method (DRM), a new method which consists of four sub-methods is proposed; and finally, several examples are investigated to verify the characteristics of the proposed method.

Two types of reference variables for the frequently used nine types of variables are proposed, and four sub-methods for estimating the moments of responses are presented by combining with the univariate and bivariate DRM.

In this paper, the number of nodes of one-dimensional integrals is determined subjectively and empirically; therefore, determining the number of nodes rationally is still a challenge.

Through the linear transformation, the optimal reference variables of random variables are presented, and a PEM based on the linear transformation is proposed which is efficient and easy to implement. By the numerical method, the quasi-optimal reference variables are given, which is the basis of the proposed PEM based on the quasi-optimal reference variables, together with high efficiency and ease of implementation.

The purpose of this study is to explore the impact of work-to-family conflict (WFC) on unethical pro-family behavior (UPFB) and work engagement (WE) among Chinese female leaders. In addition, this study investigates the mediating role of work-to-family guilt (WFG) and the moderating role of family centrality (FC) in these relationships.

A quantitative approach was adopted, involving the collection of data through online questionnaires administered at three time points. These data were analyzed using hierarchical regression and the bootstrapping method to test the proposed hypotheses.

WFC exhibited a significant positive correlation with UPFB and a negative correlation with WE; WFG played a mediating role in the relationships between WFC and both UPFB and WE; and FC had a significant moderating effect on the relationship between WFC and WE.

This study sheds light on a model of WFC and its related effects, reveals how WFC affects UPFB and WE and uncovers the mediating role of WFG and the moderating role of FC; pays attention to a unique organizational behavior, UPFB, which enriches research on the antecedents influencing such behaviors; and examines Chinese female leaders in organizations, their current experience of WFC and the resulting psychological and behavioral outcomes.

The purpose of this paper is to study the pipe-type electromagnetic induction heating device under power frequency condition.

To reduce eddy current loss and improve heating efficiency, the structure of a pipe-type power-frequency electromagnetic heating device was optimized. Based on the maximum load flow formula, a parallel excitation winding structure is designed, and the distribution of electromagnetic field under four different powers is analyzed by simulation. Four heating modes were proposed according to the structure of diversion ring, inner wall and outer wall. Two heating modes with better heating effect were obtained by comprehensively considering the factors such as magnetic field distribution, thermal power and energy consumption.

The double-wall structure of the pipe-type electromagnetic heating device can make the heat source distribution more uniform, and the use of power-frequency power supply can increase security, the installation of diversion ring can make the heating more sufficient and the heating efficiency of the two heating methods selected according to the structural performance is more than 90%.

In view of the medium or high frequency of pipe-type electromagnetic heating device, it is necessary to configure high power electronic frequency conversion drive system, and eddy current can only be produced on the tube wall, resulting in uneven distribution of heat sources. A pipe-type power-frequency electromagnetic heating device with double-wall structure was proposed.

The assumption that the family migrates as a unit downplays migrants’ circularity. This chapter focuses on China's rural–urban labor migrants that travel back and forth between the sites of work and home community and between places of work. I argue that migrants and their households pursue work flexibility in order to obtain the best of the urban and rural worlds, by gaining earnings from urban work and at the same time maintaining social and economic security in the countryside. Work flexibility demands flexibility in household organization, in the form of division of labor and collaboration between genders, generations, and households. Based on a study in Sichuan, I examine household biographies and narratives to identify migrants’ work and household strategies.

Migrants change jobs frequently, switch from one type of work to another and one location to another readily, and often return to the home village for months or even years before pursuing migrant work again. Not only are migrants ready to split the household between the city and the countryside, but also they frequently change from one form of division of labor to another. The inside–outside model, where the wife stays in the village and the husband does migrant work, used to be the dominant arrangement. Over time, the outside–outside model, where both the husband and wife migrate to work and leave behind other family members, is increasingly popular. This is facilitated by intergenerational and interhousehold division of labor in the form of assistance by the extended family. Intergenerational division of labor takes place when the second generation is replacing the parents in migrant work. This research's findings support the notion that rural–urban migrants are fast becoming a hybrid segment of Chinese society, playing dual roles of farmers and urban workers and straddling the peasant and urban worlds.