Search results

The purpose of this paper is to consider both sides of a back‐to‐back AC‐DC‐AC interface.

The paper presents a mathematical analysis, simulation, laboratory test in scaled model.

The two main findings comprised concept of control methods for grid AC‐DC‐AC converter applied in renewable energy sources with variable speed operation under distorted grid. Active filtering functionality in case of non‐linear current of a parallel load. Second, a control algorithm dedicated for two‐level AC‐DC converter applied in industrial networks with high‐order harmonics compensation working under hard conditions – balanced and unbalanced voltage dips.

The paper shows preliminary results for AC‐DC‐AC converter and active filter (AF) during voltage dips and for harmonics compensation. Control methods and/or topology should be improved and tested in scale and after at high‐power system.

Power quality supplied/received to/from the grid can be increased. In case of low‐cost system only AF can be applied to existing non‐linear receivers. Moreover, in case of full AC‐DC‐AC converter energy saving and production is possible.

Presented control methods give satisfactory results. Paper presents laboratory results for grid and machine side two different power circuits during steady states and transients. Moreover, active filtering operation during voltage dips is presented.

The objective is the application of vibration analysis for the detection and diagnosis of low isolation between the stator coil wind and the voltage phase unbalance in induction motors with different numbers of poles. The purpose of this paper is to provide an approach for maintenance engineers for diagnosis electrical fault through the vibration analyses.

A detailed review of previous work carried out by some researchers and maintenance engineers in the area of machine fault detection is performed. By vibration analysis, the spectra were collected, which used to analyze the failure. Vibration spectra could detect particular characteristic for each fault in an initial condition, so the machine health can be preserved.

Results show the efficiency of the technique of vibration analysis and their relevance to detect and diagnose faults in different induction motors. In this way, it may be included in future predictive maintenance programs.

The paper presents a laboratory investigation carried out through an experimental set-up for the study of fault, mainly related to the stator winding inter-turn short circuit and voltage phase unbalance.

The main contribution of the paper has been the characterization of one more tool that makes the predictive maintenance process more efficient, effective and faster, increasing the reliability and availability of equipment.

The purpose of this study is to eliminate voltage harmonics and instantly measure the positive sequence fundamental voltage during unbalanced grid conditions, the dual second-order generalized integrator-phase locked loop used in series hybrid filter structures is often used in grid synchronisation in three-phase networks. The preferred series active hybrid power filter simultaneously compensates for voltage balancing and current harmonics generated by non-linear loads.

This paper examines the use of renewable energy–based microgrid (MG) to support linear and non-linear loads. It is capable of synchronising with both the utility and the diesel generator unit. Power is transferred from the grid throughout a stable grid situation with minimum renewable energy generation and maximum load demand. It synchronises with diesel generator set to supply the load and form an AC MG during outages and minimum renewable power generation. In islanded and grid-connected mode, the voltage and power quality issues of the MG are controlled by static synchronous compensator and series hybrid filter.

Because of the presence of non-linear loads, reactive loads in the distribution system and the injection of wind power into the grid integrated system result power quality issues like current harmonics, voltage fluctuations, reactive power demand, etc.

The voltage at the load (linear and non-linear) is regulated, and the power factor and total harmonic distortions were improved with the help of the series hybrid filter.

The purpose of this paper is to introduce an algorithm based only on local extreme analysis of a time sequence to further the detection and diagnosis of inter-turn short circuits and unbalanced voltage supply using vibration signals.

The upper and lower extreme envelopes from a modulated and oscillatory time sequence present a particular characteristic being of, theoretically, symmetrical versions with regard to amplitude reflection around the time axis. Thus, one may say that they carry the same characteristics in terms of waveforms and, consequently, frequency content. These envelopes can easily be built by an interpolation process of the local extremes, maximums and minimums, from the original time sequence. Similar to modulator signals, they contain more detailed and useful information about the required electrical fault frequencies.

Results show the efficiency of the proposed algorithm and its relevance to detecting and diagnosing faults in induction motors with the advantage of being a technique that is easy to implement in any computational code.

A laboratory investigation carried out through an experimental setup for the study of faults, mainly related to the stator winding inter-turn short circuit and voltage phase unbalance, is presented.

The main contribution of the work is the presentation of an alternative tool to demodulate signals which may be used in real applications like the detection of faults in three-phase induction machines.

The purpose of this paper is to investigate a control strategy to fulfill low-voltage ride through (LVRT) requirements in wind energy conversion system (WECS).

This paper considers an active front-end converter of a grid connected WECS working under grid fault conditions. Two strategies based on symmetrical components are studied and proposed: the first one considers control only for positive sequence control (PSC); the second one considered a dual controller for positive and negative sequence controller (PNSC). The performance of each strategy is studied on LVRT requirements fulfillment.

This paper shows presents a control strategy based on symmetrical component to keep the operation of grid-connected WECS under unsymmetrical grid fault conditions.

This work is being applied to a 2 kVA laboratory prototype. The lab prototype emulates a grid connected WECS.

This paper validate the PNSC strategy to LVRT requirements fulfillment by experimental results obtained for a 2 kVA laboratory prototype. PNSC strategy allows constant active power delivery through grid-voltage dips. In addition, the proposed strategy is able to grid-voltage support by injection of reactive power. Additional features are incorporated to PNSC: sequence separation method using delay signal cancellation and grid frequency identification using phase locked loop.

The impact of the loop current (LC) on the motor magnetic field in the analysis of the inter-turn short circuit (ITSC) fault is always ignored. This paper made a comparative study on the electromagnetic field of permanent magnet synchronous motors (PMSM). The purpose of this study is to explore the necessary of the LC existing in the fault analysis and the electromagnetic characteristics of the PMSM with the ITSC fault when taking into account the LC.

Based on the finite element method (FEM), the fault model was established, and the magnetic density of the fault condition was analyzed. The induced electromotive force (EMF) and the LC of the short circuit ring were studied. The three-phase induced EMF and the unbalance of the three-phase current under the fault condition were studied. Finally, a prototype test platform was built to obtain the data of the fault.

The influence of the fault on the magnetic density was obtained. The current phase lag when the ITSC fault occurs causes the magnetic enhancement of the armature reaction. The mechanism that LC hinders the flux change was revealed. The influence of the fault on the three-phase-induced EMF symmetry, the three-phase current balance and the loss was obtained.

The value of the LC in the short circuit ring and the influence of it on the motor electromagnetic field were obtained. On the basis of the electromagnetic field calculation model, the sensitivity of the LC to the magnetic density, induced EMF, current and loss were analyzed.

In the event of a DC short-circuit fault in a flexible DC power grid, the high peak value of the fault current puts forward more stringent requirements on the DC circuit breaker. The existing fault current cutoff mainly focuses on changing the topology structure. To suppress the development of fault current and reduce the investment cost of the DC grid, this paper aims to propose a dual-loop active current-limiting control based on energy difference.

Firstly, the equivalent circuit at fault is established, and the parameters related to the fault current are analyzed. Then, the relationship between the output voltage change of the bridge arm and the difference between the AC and DC energy is deduced. Finally, the experimental results are discussed on the real-time simulation platform Opal-RT.

The proposed current-limiting measures can greatly reduce the fault current, reduce the breaking current of the circuit breaker and increase the capacitor voltage during the fault period, which is beneficial to the stability of the AC system. It is verified that the proposed method is also applicable to a certain high-resistance fault.

This paper applies the method of AC fault to DC fault and deduces the relationship between energy difference and voltage variation corresponding to different step lengths based on digital simulation. In addition, two variables are used as control structure parameters to reduce the probability of system misoperation.

A standalone microgrid (MG) is able to use local renewable resources and reduce the loss in long distance transmission. But the single-phase device in a standalone MG can cause the voltage unbalance condition and additional power loss that reduces the cycle life of battery. This paper proposes an energy management strategy for the battery/supercapacitor (SC) hybrid energy storage system (HESS) to improve the transient performance of bus voltage under unbalanced load condition in a standalone AC microgrid (MG).

The SC has high power density and much more cycling times than battery and thus to be controlled to absorb the transient and unbalanced active power as well as the reactive power under unbalanced condition. Under the proposed energy management design, the battery only needs to generate balanced power to balance the steady state power demand. The energy management strategy for battery/SC HESS in a standalone AC MG is validated in simulation study using PSCAD/EMTDC.

The results show that the energy management strategy of HESS maintains the bus voltage and eliminates the unbalance condition under single-phase load. In addition, with the SC to absorb the reactive power and unbalanced active power, the unnecessary power loss in battery is reduced with shown less accumulate depth of discharge and higher average efficiency.

With this technology, the service life of the HESS can be extended and the total cost can be reduced.

This paper aims to propose a novel grid current control strategy for grid-connected voltage source converters (VSCs) under unbalanced grid voltage conditions.

A grid voltage dynamic model is represented in symmetrical positive and negative sequence reference frames. A proportional controller structure with a first-order low-pass filter disturbance observer (DOB) is designed for power control in unbalanced voltage conditions. This controller is capable of meeting the positive sequence power requirements, and it also eliminates negative sequence power components which cause double-frequency oscillations on power. The symmetrical components are calculated by using the second-order generalized integrator-based observer, which accurately estimates the symmetrical components.

Proportional current controllers are sufficient in this study in a wide range of operating conditions, as DOB accurately estimates and feed-forwards nonlinear terms which may be deteriorated by physical and operating conditions. This is the first reported scheme which estimates the VSC disturbances in terms of symmetrical component decomposition and the DOB concept.

The proposed method does not require any grid parameter to be known, as it estimates nonlinear terms with a first-order low-pass filter DOB. The proposed control system is implemented on a dSPACE ds1103 digital controller by using a three-phase, three-wire VSC.

This paper presents control strategy of VSC connected to the unbalanced grid in stationary coordinates system. The algorithm shown in the paper can be applied to typical inverter to reduce or even eliminate oscillation of DC‐link voltage under unbalanced operation. That has a direct influence on constant flow of p component of power which is essential for drives system for reducing torque ripples.

The presented strategy of control assumes that orientation of grid voltage and line current vectors hodographs have to be opposite. Mathematical analysis and simulation has been done. Laboratory tests on low power has also been carried out.

This method leads to fixed p component of power flow and fixed DC bus voltage. The presented idea of control may cause reduction of voltages asymmetry in three‐phase network with significant impedance (local grid, microgrid, isolated grid).

For 50 Hz power system, the presented control strategy has at least 5 ms response time because calculations are based on current and 5 ms delayed values of grid voltage. The paper presents only a simple steady state laboratory test that has been done in low scale of voltage and current.

The paper shows an example of implementation of the method with simple dead‐beat current controller based on DSP microprocessor. The algorithm can be easy applied in a DC/AC converter for elimination DC‐link oscillations under unbalanced working conditions.

Control methods presented in many other papers always provide sinusoidal, symmetrical three‐phase currents irrespective of grid voltage symmetry. The presented idea of control causes reduction of DC‐Link voltage and p, q components of power oscillations due to grid voltage asymmetry.