Search results

The utilisation of renewable energy sources for generating electricity and potable water is one of the most sustainable approaches in the current scenario. Therefore, the current research aims to design and develop a novel co-generation system to address the electricity and potable water needs of rural areas.

The cogeneration system mainly consists of a solar parabolic dish concentrator (SPDC) system with a concentrated photo-voltaic module at the receiver for electricity generation. It is further integrated with a low-temperature thermal desalination (LTTD) system for generating potable water. Also, a novel corn cob filtration system is introduced for the pre-treatment to reduce the salt content in seawater before circulating it into the receiver of the SPDC system. The designed novel co-generation system has been numerically and experimentally tested to analyse the performance at Karaikal, U.T. of Puducherry, India.

Because of the pre-treatment with a corn cob, the scale formation in the pipes of the SPDC system is significantly reduced, which enhances the efficiency of the system. It is observed that the conductivity, pH and TDS of seawater are reduced significantly after the pre-treatment by the corncob filtration system. Also, the integrated system is capable of generating 6–8 litres of potable water per day.

The integration of the corncob filtration system reduced the scaling formation compared to the general circulation of water in the hoses. Also, the integrated SPDC and LTTD systems are comparatively economical to generate higher yields of clean water than solar stills.

Many European countries suspended mandatory conscription after the Cold War, and especially between 2000 and 2010. However, with the changing security situation in Europe, more and more countries are considering the re-introduction of the draft. That is why, it is important to evaluate the impact of conscription on draftees, including its effect on fertility outcomes. Additionally, fertility is of particular interest because birth rates have been below replacement levels in most European countries at least in the last two decades. This, combined with the increase in life expectancy, has contributed to aging population and raises concerns about the future economic prospects and sustainability of the continent. Military service could be related to fertility in several ways. Compulsory service for men would affect the marriage market and subsequently child-bearing outcomes. For example, men who serve in the military would have to delay higher education at least by a year, given that they plan to continue their education after high school. One possibility is that this leads to older men meeting younger women if partners meet at college. Alternatively, in case the partners know each other prior to the draft, service could delay marriage by up to a year due to the conscription, postponing planning and having children, and potentially having fewer children as women might be less able or less willing to have a child after a certain age. Finally, some men who plan and would otherwise continue their education might choose to not do so or to further postpone it once they disattach from studying during their service. For some men, this might influence their marital and subsequent fertility outcomes. In either of these scenarios, a draft or its suspension is likely to be connected to fertility.

This study examines the effect of the suspension of the draft in Spain in December 2001 on three fertility outcomes of men that would have been drafted in the absence of the suspension. The author performs the analysis in a difference-in-differences framework. Potential concerns and policy implications are also discussed.

The findings suggest that after the suspension of the draft, individuals started to have their first child earlier given that they decide to have children. Consistent with the overall time trend, they became less likely to have a child and started to have fewer children. However, the age at birth of the first child decreased while the number of children and the likelihood of having a child increased for men relative to women, after compared to before the suspension of the mandatory draft.

The author extends prior literature by investigating the effect of the abolition of compulsory military service in Spain in December 2001 on fertility. This is novel is several ways. First, to the best of the author’s knowledge, previous literature has examined the effect of this Spanish reform only on labor market outcomes prior to men's conscription. Second, even for other countries that terminated the compulsory draft, fertility has been under-studied, providing an opportunity for further exploration. Third, this analysis is based on rich Census data, representative of the population in Spain. Finally, given the inconclusive findings of previous studies for other countries and the proposed re-introduction of the draft in some parts of Europe, additional evidence of the effect of the conscription has important policy implications necessary for the evaluation of future military service policy decisions.

The purpose of the article is to identify relevant criteria for decision support in the implementation of waste-to-energy (WtE)-based systems.

The methodology is a simple case study with a qualitative approach. Five experts involved in the project of a thermoelectric power plant qualitatively evaluated, on a Likert scale, a decision model with 15 indicators derived from recent studies. The research object was the first stage of a project to implement a thermoelectric plant employing municipal solid waste (MSW) in southern Brazil.

The study identified 15 criteria supporting the decision-making process regarding WtE implementation for MSW in a mid-sized city in southern Brazil. The study identified that compliance with MSW legislation, compliance with energy legislation, initial investment and public health impact are the most influential criteria. The study offered two models for decision processes: a simplified one and a complete one, with ten and fifteen indicators, respectively.

The study concerns mid-sized municipalities in southern Brazil.

Municipal public managers have now a methodology based on qualitative evaluation that admits multiple perspectives, such as technical, economic, environmental and social, to support decision-making processes on WtE technologies for MSW.

MSW management initiatives can yield jobs and revenues for vulnerable populations and provide a correct destination for MSW, mainly in developing countries.

The main originality is that now municipal public decision-makers have a structured model based on four constructs (technical, economic, environmental and social) deployed in 15 indicators to support decision-making processes involving WtE and MSW management.

This paper aims to investigate the corrosion resistance of two types of coatings – one is ceria sol coating and the other is ceria sol coating modified by ZnO nanoparticles on 7075 aluminum alloy in 3.5% NaCl solution.

Aluminum alloys were dipped into ceria sol and ceria sol modified by ZnO nanoparticles separately and removed after 10 min from the solutions and dried at 110°C for 30 min and heated at 500 °C for 30 min to form the coatings. The coatings have been characterized by using field emission scanning electron microscopy (FE-SEM), electrochemical impedance spectroscopy (EIS), X-ray diffraction (XRD) and energy dispersive spectroscopy (EDS). The EIS tests were performed in a corrosive solution of 3.5% NaCl.

The results showed that the coating of ceria sol modified by ZnO nanoparticles has higher corrosion resistance than the ceria sol coating and the bare sample. Also, the best efficiency is related to aluminum sample immersion after 1 h in NaCl corrosive solution for coating modified by ZnO nanoparticles.

In this research, the modification of ceria sol coating by ZnO nanoparticles had an effect on improving the corrosion behavior of aluminum alloy. It is also understood that modification of coatings is an effective parameter on corrosion resistance.

Globally, consumer’s inclination towards functional foods had noticed due to their greater health consciousness coupled with enhanced health-care cost. The fact that probiotics could promote a healthier gut microbiome led projection of probiotic foods as functional foods and had emerged as an important dietary strategy for improved human health. It had established that ice cream was a better carrier for probiotics than fermented milked due to greater stability of probiotics in ice cream matrix. Global demand for ice cream boomed and probiotic ice cream could have been one of the most demanded functional foods. The purpose of this paper was to review the technological aspects and factors affecting probiotic viability and to standardize methodology to produce functional probiotic ice cream.

Attempt was made to search the literature (review and researched papers) to identify diverse factors affecting the probiotic viability and major technological challenge faced during formulation of probiotic ice cream. Keywords used for data searched included dairy-based functional foods, ice cream variants, probiotic ice cream, factors affecting probiotic viability and health benefits of probiotic ice cream.

Retention of probiotic viability at a level of >10⁶ cfu/ml is a prerequisite for functional probiotic ice creams. Functional probiotic ice cream could have been produced with the modification of basic mix and modulating technological parameters during processing and freezing. Functionality can be further enhanced with the inclusion of certain nutraceutical components such as prebiotics, antioxidant, phenolic compounds and dietary fibres. Based upon reviewed literature, suggested method for the manufacture of functional probiotic ice cream involved freezing of a probiotic ice cream mix obtained by blending 10% probiotic fermented milk with 90% non-fermented plain ice cream mix for higher probiotic viability. Probiotic ice cream with functional features, comparable with traditional ice cream in terms of technological and sensory properties could be produced and can crop up as a novel functional food.

Probiotic ice cream with functional features may attract food manufacturers to cater health-conscious consumers.

This study aims to assess the impact of participation in self-help group (SHG) on the psychological empowerment of rural tribal women.

Primary data was collected using multistage random sampling from the rural women of Jharkhand, India. The propensity score matching method was adopted using the psmatch2 command in STATA.

The results show a significant positive change in women’s self-esteem, self-confidence, self-efficacy, autonomy, knowledge and skills, reduction in agony and quality of life after participation in SHG. This reveals that participation in SHG has a significant positive impact on the psychological empowerment of rural tribal women.

Despite the numerous studies on rural women’s empowerment, there is little evidence of literature focusing on the impact of participation in SHG on psychological empowerment, specifically in the tribal context. This study primarily focuses on women belonging to the scheduled tribe category of Jharkhand, one of the poorest states of India.

Cancer has become a priority among today’s health problems. Therefore, providing facilities that ensure high-quality cancer treatment has become an essential design problem. Additionally, a considerable number of studies have introduced the ‘healing environment concept’ as a substantial input for healthcare buildings. The purpose of this paper is to present a design guide for cancer treatment services that is compatible with the healing environment concept.

In this context, studies on the healing environment have been analyzed, and the legislation of some selected countries has been assessed. Then, all the filtered data are used to form the design guideline for chemotherapy department, radiation oncology department and inpatient care services under a new series of analysis criteria.

The resulting principles are revealed according to the criteria of general settlement principles, internal function relations, medical necessities, user experience, interior design, social interaction/privacy, safety, landscape design and outdoor relations by the help of proposed plans, diagrams and schematic drawings.

This research constitutes the first and yet only study in its field that aims to increase efficiency and user satisfaction and provide better patient-centered care while providing a design guide on health-care architecture.

The relationship between industrial policy and exploratory innovation is imperfect.

The authors use Chinese high-tech enterprise identification policy (HTEP) as a natural experimental group to test policy impacts, spillover effects and mechanisms of action.

First, HTEP promotes exploratory innovation. In addition, HTEP has a greater impact on non-exploratory innovation. Second, HTEP has spillover effects in two phases: HTEP (2008) and the 2016 policy reform. HTEP affects exploratory innovation in nearby non-high-tech firms, and the policy effect decreases monotonically with increasing distance from the treatment group. Third, HTEP affects innovation capacity through financing constraints, technical personnel flow and knowledge flow, which explains not only policy effects but also spillover effects. Fourth, the analysis of policy heterogeneity shows that the 2016 policy reforms reinforce the positive effect of HTEP (2008). By deducting the effects of other policies, the HTEP effect is found to be less volatile. In terms of the continuity of policy identification, continuous uninterrupted identification has a crucial impact on the improvement of firms’ innovation capacity compared to repeated certification and certification expiration. Finally, HTEP has a crowding-out effect in state-owned enterprises and large firms’ innovation.

This paper contributes to the existing literature in several ways. First, the authors enrich the literature on industrial policy through exploratory innovation research. While previous studies have focused on R&D investment and patents (Dai and Wang, 2019), exploratory innovation helps firms break away from the inherent knowledge mindset and achieve sustainable innovation. Second, few studies have explored the characteristics of industrial policies. In this paper, the authors subdivide the sample into repeated certification, continuous certification and certification expiration according to high-tech enterprise identification. In addition, the authors compare the differences in policy implementation effects between the 2016 policy reform and the 2008 policy to provide new directions for business managers and policy makers. Third, innovation factors guided by industrial policies may cluster in specific regions, which in turn manifest externalities. This is when the policy spillover effect is worth considering. This paper fills a gap in the industrial policy literature by examining the spillover effects. Finally, this paper also explores the mechanisms of policy effects from three perspectives: financing constraints, technician mobility and knowledge mobility, which can affect not only the innovation of beneficiary firms directly but also indirectly the innovation of neighboring non-beneficiary firms.

This paper aims to achieve phosphating via optimal features of Mg metal as a suitable base coating, which is considered for other properties such as barrier properties against the passage of several factors.

In this research, in the phosphate bath, immersion time, temperature and the content of sodium nitrite as an accelerator were changed.

As a result, increasing the immersion time of AZ31 Mg alloy samples in the phosphating bath as well as increasing the ratio of sodium dodecyl sulfate (SDS) concentration to sodium nitrite concentration in the phosphating bath formulation increase the mass of phosphating formed per unit area of the Mg alloy. The results of the scanning electron microscope test showed phosphating is not completely formed in short immersion times, which is a thin and uneven layer.

Mg and its alloys are sensitive to galvanic corrosion, which would lead to generating several holes in the metal. As such, it causes a decrease in mechanical stability as well as an unfavorable appearance.

Mg is used in several industries such as automobile and computer parts, mobile phones, astronaut compounds, sports goods and home appliances.

Nevertheless, Mg has high chemical reactivity, so an oxide-hydroxide layer is formed on its surface, which has a harmful effect on the adhesion and uniformity of the coating applied on Mg.

By increasing the ratio of SDS concentration to sodium nitrite concentration in the phosphating bath, the corrosion resistance of the phosphating increases.

The aim of this paper is to solve the toxic and harmful problems caused by traditional volatile corrosion inhibitor (VCI) and to analyze the effect of the layered structure on the enhancement of the volatile corrosion inhibition prevention performance of amino acids.

The carbon dots-montmorillonite (DMT) hybrid material is prepared via hydrothermal process. The effect of the DMT-modified alanine as VCI for mild steel is investigated by volatile inhibition sieve test, volatile corrosion inhibition ability test, electrochemical measurement and surface analysis technology. It demonstrates that the DMT hybrid materials can improve the ability of alanine to protect mild steel against atmospheric corrosion effectively. The presence of carbon dots enlarges the interlamellar spacing of montmorillonite and allows better dispersion of alanine. The DMT-modified alanine has higher volatilization ability and an excellent corrosion inhibition of 85.3% for mild steel.

The DMT hybrid material provides a good template for the distribution of VCI, which can effectively improve the vapor-phase antirust property of VCI.

The increased volatilization rate also means increased VCI consumption and higher costs.

Provides a new way of thinking to replace the traditional toxic and harmful VCI.

For the first time, amino acids are combined with nano laminar structures, which are used to solve the problem of difficult volatilization of amino acids.