Search results

Rainfall is one of the main atmospheric conditions that significantly affect the aerodynamic performance of the low Reynolds number flights. In this paper, the adverse effects of rain on the aerodynamic performance of a two-dimensional (2D) airfoil with a chord-based low Reynolds number of 2 × 10⁵ and the mini-unmanned aerial vehicle (UAV) for various flight conditions, i.e. 0°–40° at Mach number 0.04 were studied numerically. The purpose of this study is to explore the aerodynamic penalties that affect the liquid water content (LWC = 5.33) of the airfoil and UAV performance in rain under different flying conditions.

The Eulerian–Lagrangian two-phase flow method is adopted to simulate the rain environment over an airfoil and mini-UAV aerodynamic performances. The Reynolds Averaged Navier–Stokes equations are considered to solve the time-averaged equations of motion for fluid flow.

The effect of rainfall on the airfoil and mini-UAV is studied numerically and validated experimentally. For 2D airfoil, the lift and drag coefficients for both numerical and experimental results show a very good correlation at Reynolds number 2 × 10⁵. For three-dimensional (3D) mini-UAV, the lift and drag coefficients for both numerical and experimental results show a very good correlation at Mach number 0.04. The raindrops distribution around the airfoil, premature trailing edge separation, boundary-layer velocity profiles at five different chord positions (i.e. LE, 0.25c, 0.5c, 0.75c and 0.98c) on the upper surface of the airfoil, water film height and the location of rivulet formation on the upper surface of the airfoil are also presented.

For 2D airfoil, the recorded maximum variation of the coefficient of lift and lift-to-drag (L/D) ratio is observed to be 5.33% at an 8° and 10.53% at a 4° angle of attack (AOA) between numerical and experimental results under the influence of rainfall effect for LWC = 5.33. The L/D ratio percentage degradation is seen to be 61.9% at an AOA of 0°–2° for the rain environment. For 3D mini-UAV, the recorded maximum variation of the coefficient of lift and L/D ratio are observed to be 2.84% and 4.60% at a 30° stall AOA under the influence of rainfall effect for LWC = 5.33. The numerical results are impressively in agreement with the experimental results. UAV designers will benefit from the findings presented in this paper. This will be also helpful for training the pilots to control the airplanes in a rain environment.

The purpose of this paper is to analyse an actual representation of ice accretions, which are important during the certification process.

Ice accretion experiments are conducted in a low-speed subsonic wind tunnel testing facility to evaluate the influence of various ice shapes around the airfoil sections. Ice accumulation changes the shapes of local airfoil sections and thereby affects the aerodynamic performance characteristics of the considered NACA 23012 profile. The ice profiles are impregnated using balsa wood with glace, horn and mixed ice accretion cases for the detailed experimental investigation.

Computational fluid dynamics analysis is done to compute the influence of different ice shapes on the aerodynamic coefficients (C_l and C_d) while ice accretion occurs at the leading edge of the airfoil sections. It is observed that the C_l and C_d modified immediately more than 40% as compared to the clean wing configuration. In the same fashion, the skin friction coefficient also abruptly changes for different ice shapes that have the potential to induce flutter at the critical speed of the airplane. The computational solutions are further validated through wind tunnel experiments and recent literature concerning certification for flight in icing conditions.

The ice accretion study on the aerodynamic surfaces can also be extended for wind turbine blades installed at different cold regions around the globe. Further, the propeller icing influences the entire rotorcraft aerodynamics at low temperature conditions and the findings of this study are strongly connected with such problems.

The aerodynamic characteristics of the baseline airfoil are greatly affected by the ice accretion problem. Although flight through icing condition endures for a short duration, the takeoff path and decision speed are determined based on airplane drag as per federal aviation regulations. Hence, the proposed study is focussed on a cost-effective approach to predict the effect of ice accretion to achieve optimum performance.

The high lift devices are effective at high angle of attack to increase the coefficient of lift by increasing the camber. But it affects the low angle of attack aerodynamic performance by increasing the drag. Hence, they have made as a movable device to deploy only at high angles of attack, which increases the design and installation complexities. This study aims to focus on the comparison of aerodynamic efficiency of different conventional leading edge (LE) slat configurations with simple fixed bioinspired slat design.

This research analyzes the effect of LE slat on aerodynamic performance of CLARK Y airfoil at low and high angles of attack. Different geometrical parameters such as slat chord, cutoff, gap, width and depth of LE slat have been considered for the analysis.

It has been found that the LE slat configuration with slat chord 30% of airfoil chord, forward extension 8% of chord, dip 3% of chord and gap 0.75% of chord gives higher aerodynamic efficiency (C_l/Cd) than other LE slat configurations, but it affects the low angles of attack aerodynamic performance with the deployed condition. Hence, this optimum slat configuration is further modified by closing the gap between LE slat and the main airfoil, which is inspired by the marine mammal’s nose. Thus increases the coefficient of lift at high angles of attack due to better acceleration over the airfoil nose and as well enhances the aerodynamic efficiency at low angles of attack.

The two-dimensional computational analysis has been done for different LE slat’s geometrical parameters at low subsonic speed.

This bio-inspired nose design improves aerodynamic performance and increases the structural strength of aircraft wing compared to the conventional LE slat. This fixed design avoids the complex design and installation difficulties of conventional movable slats.

The findings will have significant impact on the fields of aircraft wing and wind turbine designs, which reduces the design and manufacturing complexities.

Different conventional slat configurations have been analyzed and compared with a simple fixed bioinspired slat nose design at low subsonic speed.

Under this heading are published regularly abstracts of all Reports and Memoranda of the Aeronautical Research Council, Reports and Technical Notes of the United States National Advisory Committee for Aeronautics and publications of other similar Research Bodies as issued.

This paper aims to investigate the effects of a dielectric barrier discharge (DBD) plasma actuator (PA) qualitatively on aerodynamic characteristics of a 3 D-printed NACA 4412 airfoil model.

Airflow visualization study was performed at a Reynolds number of 35,000 in a small-scale open-loop wind tunnel. The effect of plasma actuation on flow separation was compared for the DBD PA with four different electrode configurations at 10°, 20° and 30° angles of attack.

Plasma activation may delay the onset of flow separation up to 6° and decreases the boundary layer thickness. The effects of plasma diminish as the angle of attack increases. Streamwise electrode configuration, in which electric wind is produced in a direction perpendicular to the freestream, is more effective in the reattachment of the airflow compared to the spanwise electrode configuration, in which the electric wind and the free stream are in the same direction.

The Reynolds number is much smaller than that in cruise aircraft conditions; however, the results are promising for low-velocity subsonic airflows such as improving control capabilities of unmanned aerial vehicles.

Superior efficacy of spanwise-generated electric wind over streamwise-generated one is demonstrated at a very low Reynolds number. The results in the plasma aerodynamics literature can be reproduced using ultra-low-cost off-the-shelf components. This is important because high voltage power amplifiers that are frequently encountered in the literature may be prohibitively expensive especially for resource-limited university aerodynamics laboratories.

Under this heading are published regularly abstracts of all Reports and Memoranda of the Aeronautical Research Council, Reports and Technical Notes of the United States National Advisory Committee for Aeronautics and publications of other similar Research Bodies as issued.

Under this heading are published regularly abstracts of all Reports and Memoranda of the Aeronautical Research Council, Reports and Technical Memoranda of the United States National Advisory Committee for Aeronautics and publications of other similar Research Bodies as issued

Under this heading are published regularly abstracts of all Reports and Memoranda of the Aeronautical Research Council, Reports and Technical Notes of the United States National Advisory Committee for Aeronautics and publications of other similar Research Bodies as issued.

Under this heading are published regularly abstracts of all Reports and Memoranda of the Aeronautical Research Committee, Reports and Technical Notes of the United States National Advisory Committee for Aeronautics and publications of other similar Research Bodies as issued.

Under this heading are published regularly abstracts of all Reports and Memoranda of the Aeronautical Research Council, Reports and Technical Notes of the United States National Advisory Committee for Aeronautics and publications of other similar Research Bodies as issued.