Search results

1 – 10 of 17
Open Access
Article
Publication date: 2 June 2023

Sharaf AlKheder, Ahmad Alkandari, Bader Aladwani and Wasan Alkhamees

This study aims to validate a model for estimating platoon delay due to pedestrian crossing for use in Kuwait City.

Abstract

Purpose

This study aims to validate a model for estimating platoon delay due to pedestrian crossing for use in Kuwait City.

Design/methodology/approach

The model was modified slightly for the scenario used in Kuwait, in which the presence of raised crosswalk meant that all incoming traffic would slow down automatically. Using video footage to observe the site, several variables were collected, and a model was used to calculate the delays suffered by the vehicles because of pedestrian crossing. The model was validated using the actual footage and manual observation to measure the delays.

Findings

The model showed a good match fit to the observed data, as the average delays differed by 22.5% between the two methods. Following the comparison, a sensitivity analysis was made on three variables: the acceleration rate, deceleration rate, as well as the pedestrian walking time. The analysis has shown that deceleration rate has approximately twice the effect on the model than the acceleration rate has. It has also shown that the pedestrian walking time has a major effect on the model, in an almost one-to-one correlation. A 50% change of the pedestrian walking time is associated with approximately 50% change in the model’s output delay.

Originality/value

A model for estimating platoon delay because of pedestrian crossing was validated for use in Kuwait City. The model was modified slightly for the scenario used in Kuwait, in which the presence of raised crosswalk meant that all incoming traffic would slow down automatically.

Details

Smart and Resilient Transportation, vol. 5 no. 1
Type: Research Article
ISSN: 2632-0487

Keywords

Open Access
Article
Publication date: 18 May 2018

Winifred Chepkoech, Nancy W. Mungai, Silke Stöber, Hillary K. Bett and Hermann Lotze-Campen

Understanding farmers’ perceptions of how the climate is changing is vital to anticipating its impacts. Farmers are known to take appropriate steps to adapt only when they…

9141

Abstract

Purpose

Understanding farmers’ perceptions of how the climate is changing is vital to anticipating its impacts. Farmers are known to take appropriate steps to adapt only when they perceive change to be taking place. This study aims to analyse how African indigenous vegetable (AIV) farmers perceive climate change in three different agro-climatic zones (ACZs) in Kenya, identify the main differences in historical seasonal and annual rainfall and temperature trends between the zones, discuss differences in farmers’ perceptions and historical trends and analyse the impact of these perceived changes and trends on yields, weeds, pests and disease infestation of AIVs.

Design/methodology/approach

Data collection was undertaken in focus group discussions (FGD) (N = 211) and during interviews with individual farmers (N = 269). The Mann–Kendall test and regression were applied for trend analysis of time series data (1980-2014). Analysis of variance and least significant difference were used to test for differences in mean rainfall data, while a chi-square test examined the association between farmer perceptions and ACZs. Coefficient of variation expressed as a percentage was used to show variability in mean annual and seasonal rainfall between the zones.

Findings

Farmers perceived that higher temperatures, decreased rainfall, late onset and early retreat of rain, erratic rainfall patterns and frequent dry spells were increasing the incidences of droughts and floods. The chi-square results showed a significant relationship between some of these perceptions and ACZs. Meteorological data provided some evidence to support farmers’ perceptions of changing rainfall. No trend was detected in mean annual rainfall, but a significant increase was recorded in the semi-humid zone. A decreasing maximum temperature was noted in the semi-humid zone, but otherwise, an overall increase was detected. There were highly significant differences in mean annual rainfall between the zones. Farmers perceived reduced yields and changes in pest infestation and diseases in some AIVs to be prevalent in the dry season. This study’s findings provide a basis for local and timely institutional changes, which could certainly help in reducing the adverse effects of climate change.

Originality/value

This is an original research paper and the historical trends, farmers’ perceptions and effects of climate change on AIV production documented in this paper may also be representative of other ACZs in Kenya.

Details

International Journal of Climate Change Strategies and Management, vol. 10 no. 4
Type: Research Article
ISSN: 1756-8692

Keywords

Content available
Book part
Publication date: 27 June 2013

Abstract

Details

Transformational and Charismatic Leadership: The Road Ahead 10th Anniversary Edition
Type: Book
ISBN: 978-1-78190-600-2

Content available
Book part
Publication date: 20 June 2017

David Shinar

Abstract

Details

Traffic Safety and Human Behavior
Type: Book
ISBN: 978-1-78635-222-4

Content available
Book part
Publication date: 11 July 2007

Abstract

Details

Transitions in Latin America and in Poland and Syria
Type: Book
ISBN: 978-1-84950-469-0

Open Access
Book part
Publication date: 18 July 2022

Christian Versloot, Maria Iacob and Klaas Sikkel

Utility strikes have spawned companies specializing in providing a priori analyses of the underground. Geophysical techniques such as Ground Penetrating Radar (GPR) are harnessed…

Abstract

Utility strikes have spawned companies specializing in providing a priori analyses of the underground. Geophysical techniques such as Ground Penetrating Radar (GPR) are harnessed for this purpose. However, analyzing GPR data is labour-intensive and repetitive. It may therefore be worthwhile to amplify this process by means of Machine Learning (ML). In this work, harnessing the ADR design science methodology, an Intelligence Amplification (IA) system is designed that uses ML for decision-making with respect to utility material type. It is driven by three novel classes of Convolutional Neural Networks (CNNs) trained for this purpose, which yield accuracies of 81.5% with outliers of 86%. The tool is grounded in the available literature on IA, ML and GPR and is embedded into a generic analysis process. Early validation activities confirm its business value.

Open Access
Article
Publication date: 17 June 2019

Stephen Fox, Olli Aranko, Juhani Heilala and Päivi Vahala

Exoskeletons are mechanical structures that humans can wear to increase their strength and endurance. The purpose of this paper is to explain how exoskeletons can be used to…

17976

Abstract

Purpose

Exoskeletons are mechanical structures that humans can wear to increase their strength and endurance. The purpose of this paper is to explain how exoskeletons can be used to improve performance across five phases of manufacturing.

Design/methodology/approach

Multivocal literature review, encompassing scientific literature and the grey literature of online reports, etc., to inform comprehensive, comparative and critical analyses of the potential of exoskeletons to improve manufacturing performance.

Findings

There are at least eight different types of exoskeletons that can be used to improve human strength and endurance in manual work during different phases of production. However, exoskeletons can have the unintended negative consequence of reducing human flexibility leading to new sources of musculoskeletal disorders (MSD) and accidents.

Research limitations/implications

Findings are relevant to function allocation research concerned with manual production work. In particular, exoskeletons could exacerbate the traditional trade-off between human flexibility and robot consistency by making human workers less flexible.

Practical implications

The introduction of exoskeletons requires careful health and safety planning if exoskeletons are to improve human strength and endurance without introducing new sources of MSD and accidents.

Originality/value

The originality of this paper is that it provides detailed information about a new manufacturing technology: exoskeletons. The value of this paper is that it provides information that is comprehensive, comparative and critical about exoskeletons as a potential alternative to robotics across five phases of manufacturing.

Details

Journal of Manufacturing Technology Management, vol. 31 no. 6
Type: Research Article
ISSN: 1741-038X

Keywords

Open Access

Abstract

Purpose

To compare the electromyography (EMG) features during physical and imagined standing up in healthy young adults.

Design/methodology/approach

Twenty-two participants (ages ranged from 20–29 years old) were recruited to participate in this study. Electrodes were attached to the rectus femoris, biceps femoris, tibialis anterior and the medial gastrocnemius muscles of both sides to monitor the EMG features during physical and imagined standing up. The %maximal voluntary contraction (%MVC), onset and duration were calculated.

Findings

The onset and duration of each muscle of both sides had no statistically significant differences between physical and imagined standing up (p > 0.05). The %MVC of all four muscles during physical standing up was statistically significantly higher than during imagined standing up (p < 0.05) on both sides. Moreover, the tibialis anterior muscle of both sides showed a statistically significant contraction before the other muscles (p < 0.05) during physical and imagined standing up.

Originality/value

Muscles can be activated during imagined movement, and the patterns of muscle activity during physical and imagined standing up were similar. Imagined movement may be used in rehabilitation as an alternative or additional technique combined with other techniques to enhance the STS skill.

Details

Journal of Health Research, vol. 35 no. 1
Type: Research Article
ISSN: 0857-4421

Keywords

Open Access
Article
Publication date: 28 October 2014

Julian Witjaksono, Xiaowen Wei, Suchun Mao, Wankui Gong, Yabing Li and Youlu Yuan

The purpose of this paper is to provide an overview of the current state of knowledge on the economic performance of genetically modified (GM) cotton worldwide based on a wide…

9911

Abstract

Purpose

The purpose of this paper is to provide an overview of the current state of knowledge on the economic performance of genetically modified (GM) cotton worldwide based on a wide range of data and source from available literature, and second to assess yield gain and economic performance.

Design/methodology/approach

A systematic review was captured to provide the evidence of potential benefits of GM cotton. A country-specific analysis was conducted in order to compare economic indicators and employed meta-analysis to find out the significance of the different of GM cotton over its counterpart.

Findings

This paper depicts positive impact of commercialized GM cotton in terms of net revenue, and the benefits, especially in terms of increased yields, are greatest for the mostly farmers in developing countries who have benefitted from the spill over of technology targeted at farmers in industrialized countries.

Research limitations/implications

Due to the variability of the data which came from different methodologies, it is difficult to determine the differences of the performances each individual study.

Practical implications

This, it is believed that results from this study can be useful for operations of all sizes as the authors think about what needs to be focussed on for long-term producers survival.

Originality/value

The paper clearly indicates that China is the highest cotton yield of GM cotton, the lowest cost of GM seed and the lowest cost of chemical spray compare to any other countries. Therefore, this is the fact that the adoption of GM cotton has been widely spread among the farmers across the regions in China.

Details

China Agricultural Economic Review, vol. 6 no. 4
Type: Research Article
ISSN: 1756-137X

Keywords

Open Access
Article
Publication date: 10 March 2020

Jaume García and Carles Murillo

This study investigates three issues associated with playing sports video games: the correlates of participation (and its intensity) in this type of activity, their…

11625

Abstract

Purpose

This study investigates three issues associated with playing sports video games: the correlates of participation (and its intensity) in this type of activity, their complementarity with traditional sports and their perception as sport. Given the scarcity of data on esports participation, these results can be seen as an initial approach to these issues with regard to esports.

Design/methodology/approach

Sequential, two-part and regression models are estimated using a sample of 11,018 individuals from the Survey of Sporting Habits in Spain 2015.

Findings

First, the association of the correlates follows different patterns for participation in sports video games and its intensity. Second, complementarity with traditional sports is found using different approaches. Third, young people consider this activity as a dimension of their overall interest in sports.

Practical implications

The different association of the correlates with participation in esports and its intensity can be used to define marketing and brand investment strategies. The complementarity between esports and traditional sports should influence how the actual stakeholders in sport define future strategies to favour the growth of both industries. Finally, the increasing perception of esports as a sport should influence the future organisation of multi-sport events like the Olympic Games.

Originality/value

Using sports video games participation as a proxy of esports participation, this study is the first to provide empirical evidence of the relevance of distinguishing between participation in esports and its intensity, their complementarity with traditional sports and their perception as sport.

Details

Sport, Business and Management: An International Journal, vol. 10 no. 2
Type: Research Article
ISSN: 2042-678X

Keywords

1 – 10 of 17