Search results

The paper aims to report on fabrication procedure and present microstructure and dielectric behavior of multilayer porous low-temperature cofired ceramic (LTCC) structures based on glass-cordierite and glass-alumina.

The LTCC structures were created as multi-layered composites with dense external layers and inner layers with intentionally introduced porosity. Two preparation methods were applied – subsequent casting of both kinds of slurries and conventional isostatic lamination of dried green tapes arranged in the designed order. Optical microscope observations were carried out to analyze the microstructure of green and fired multilayer structures and pore concentration. To evaluate the adhesion strength of the composite layers, pull test was performed. Dielectric behavior of the composites was studied in the frequency range 50 kHz-2 MHz.

The fabricated porous LTCC structures showed dielectric constant of 3-5.6. The lowest dielectric constant was attained for glass-cordierite composite made by the conventional tape casting/lamination/firing method from slurry with 50 per cent graphite content. The samples prepared using multiple casting were of worse quality than those fabricated in conventional process, contained irregular porosity, showed tendency for deformation and delamination and exhibited a higher dielectric constant.

Search for new low dielectric constant materials applicable in LTCC technology and new methods of their fabrication is an important task for development of modern microwave circuits.

The purpose of this paper is to report on fabrication procedure and present microstructure and dielectric behavior of willemite ceramic material with addition of 5% Li₂CO₃ as a sintering aid.

The samples were fabricated by ball milling of the ceramic powders, preparation of granulate and pressing and co-firing using temperature profile based on heating microscope observation. The dielectric properties of the material were measured by impedance spectroscopy (Hz-MHz), transmission method (GHz) and time domain spectroscopy (THz). The composition and microstructure of the material were investigated using X-ray diffraction, scanning electron microscopy and energy-dispersive spectroscopy analysis. Ceramic powder was used to fabricate a green tape and low temperature co-fired ceramics (LTCC) multilayer structures, which in the next steps of the research were examined at the angle of cooperation with conductive pastes, strength and geometric repeatability.

The fabricated material showed low sintering temperature (920°C–960°C), low dielectric constant 6.2–6.34 and low dissipation factor at the level of 0.004–0.007. As LTCC material, willemite with 5% Li₂CO₃ addition showed good compatibility with AgPd conductive paste.

Search for new materials with low dielectric constant, applicable in LTCC technology, and development of their fabrication procedure are important tasks for the progress in modern microwave circuits.

This paper aims to report on fabrication procedure and presents microstructure and dielectric behaviour of LiZn_0.92Cu_0.08PO₄ ceramic material with Li₂CO₃ as a sintering aid.

Substrates based on LiZn_0.92Cu_0.08PO₄ with Li₂CO₃ addition were prepared via solid-state synthesis, doping, milling, pressing and sintering. Characterization of the composition, microstructure and dielectric properties was performed using X-ray diffractometry, energy dispersive spectroscopy, scanning electron microscopy, impedance spectroscopy in the 100 Hz to 2 MHz range and time-domain spectroscopy in the 0.1–3 THz range.

Doped LiZnPO₄ ceramic, which exhibits a low dielectric constant of 5.9 at 1 THz and low sintering temperature of 800 °C, suitable for low temperature co-fired ceramics (LTCC) technology, was successfully prepared. However, further studies are needed to lower dielectric losses by optimising the doping level, synthesis and sintering conditions.

Search for new low dielectric constant materials applicable in LTCC technology and optimization of processing are essential tasks for developing modern microwave circuits. The dielectric characterization of doped LiZnPO₄ ceramic in the terahertz range, which was performed for the first time, is crucial for potential millimetre-wave applications of this substrate material.