Search results

It is usual when carrying out tank tests on seaplane models to include measurements of the change in attitude when pitching moments of different amounts are applied. The measurements are generally made over a range of speeds in the neighbourhood of three‐quarters of the take‐off speed, in the neighbourhood of one‐third of the take‐off speed, and also with the hull or floats at rest. Curves of attitude against speed, with different applied moments, are shown in Fig. 11, for a twin‐float seaplane, and may be regarded as typical.

The construction of cement asphalt (CA) emulsified mortar can obviously disturb the slab status after the fine adjustment. To decrease or eliminate the influence of CA mortar grouting on track slab geometry status, the effects of grouting funnel, slab pressing method, mortar expansion ratio, seepage ratio and grouting area on China Railway Track System Type (CRTS I) track slab geometry status were discussed in this paper.

Combined with engineering practice, this paper studied the expansion law of filling layer mortar, the liquid level height of the filling funnel, the pressure plate device and the amount of exudation water and systematically analyzed the influence of filling layer mortar construction on the state of track slab. Relevant precautions and countermeasures were put forward.

The results showed that the track slab floating values of four corners were different with the CA mortar grouting and the track slab corner near CA mortar grouting hole had the maximum floating values. The anti-floating effect of “7” shaped slab pressing device was more efficient than fixed-joint angle iron, and the slab floating value could be further decreased by increasing the amount of “7” shaped slab pressing devices. After CA mortar grouting, the track slab floating pattern had a close correlation with the expansion rate and water seepage rate of CA mortar over time and the expansion and water seepage rate of the mortar were faster when the temperature was high. Furthermore, the use of strip CA mortar filling under the rail bearing platform on both sides could effectively reduce the float under the track slab, and it could also save mortar consumption and reduce costs.

This study plays an important role in controlling the floating values, CA mortar dosage and the building cost of projects by grouting CA mortar at two flanks of filling space. The research results have guiding significance for the design and construction of China's CRTS I, CRTS II and CRTS III track slab.

The purpose of this research is to propose a flexible sensor with a weft-knitted float stitch structure and to explore knitting techniques that allow conductive yarns to be skin-tight and less exposed, reducing production processes and increasing productivity. Study its electrical conductivity in different yarn materials, knit processes and deformation ranges. The analysis is compared to provide some basis for the design of the electrodes.

The method includes five operations: (1) Analysis of the morphological appearance, tensile variation, fiber material properties and electrical conductivity of high-elastic and filament silver-plated conductive yarns. (2) Based on the knitting process of the floating yarn structure, three-dimensional modeling of the flexible sensor was carried out to explore the influence of knitting process changes on appearance characteristics. (3) The fabric samples are knitted by different silver-plated conductive yarns with different structures. Processing of experimental samples to finished size by advance shrinkage. (4) Measure the resistance of the experimental sample after the machine has been lowered and after pre-shrinking. Use the stretching machine to simulate a wearing experiment and measure the change in resistance of the sample in the 0–15% stretching range. (5) Analyze the influence factors on the conductive performance of the flexible sensor to determine whether it is suitable for textile flexible sensors.

For the float knitted flexible sensors, the floating wire projection is influenced by the elasticity of the fabric and the length of the floating wire. Compared to the plain knitted flexible sensors, it has less resistance variation and better electrical properties, making it suitable for making electrodes for textile structures. In addition, the knitting method is integrated with the intelligent monitoring clothing, which saves the process for the integration of the flexible sensor, realizes positioning and fixed-point knitting.

The sensor technology of the designed weft-knitted float structure is varied and can be freely combined and designed in a wide range. Within the good electrical conductivity, the flexible sensor can realize integrated knitting, positioning monitoring, integrating into the appearance of clothing. It can also focus on the wearing experience of wearable products so that the appearance of the monitoring clothing is close to the clothes we wear in our daily life.

In this paper, an integrated positioning knitting flexible sensor based on the weft knitting float structure is studied. The improved knitting process allows the sensing contact surface to be close to the skin and reduces the integration process. The relationship between the exposure of the silver-plated yarn on the clothing surface and the electrical conductivity is analyzed. Within a certain conductive performance, reduces the exposed area of the conductive yarn on the clothing surface and proposes a design reference for the flexible sensor appearance.

At present, the scale of China's floating population has reached 376 million people. Compared with the local inhabitants, the poverty problem of the floating population is more complex, and this problem should also attract the attention of all sectors of society. This paper aims to measure and analyze the multidimensional poverty of the floating population in China.

The data used in this paper are the data of the China Migrants Dynamic Survey (CMDS) in China. This survey is a large-scale national migratory population sampling survey organized by the China National Health Commission, covering 31 provinces (autonomous regions and cities) and other autonomous regions. This paper uses the dynamic monitoring and Alkire and Foster (A-F) method to study the multidimensional poverty problem of the floating population.

This study finds that income poverty is no longer the main type of poverty faced by the floating population. The multidimensional poverty of the floating population mainly occurs in the social security and education dimensions, of which social security has become the most severe poverty dimension of the floating population. From the perspective of group differences, compared with the floating population in urban areas, the multidimensional poverty of migrant workers is more serious. However, the poverty of migrant workers is mainly concentrated in one-dimensional poverty and two-dimensional poverty.

In the future, the authors should focus on the social security of the floating population in the place of influx and the education of the floating population.

Through the review of the existing literature, the authors find that the current research on the multidimensional poverty of the floating population is mainly concentrated on the migrant worker groups that move from rural areas to urban areas. However, insufficient attention is paid to the urban floating population groups moving between cities.

The purpose of this paper is to propose a new framework for time–cost trade-off. The new framework provides the optimum time–cost value taking into account the float loss impact.

The stochastic framework uses Monte Carlo Simulation to calculate the effect of float loss on risk. This is later translated into an added cost to the trade-off problem. Five examples, from literature, are solved using the proposed framework to test the applicability of the developed framework.

The results confirmed the research hypothesis that the new optimum solution will be at a higher duration and cost but at a lower risk compared to traditional methods. The probabilities of finishing the project on time using the developed framework in all five cases were better than those using the classical deterministic optimization technique.

The objective of time–cost trade-off is to determine the optimum project duration corresponding to the minimum total cost. Time–cost trade-off techniques result in reducing the available float for noncritical activities and thus increasing the schedule risks. Existing deterministic optimization technique does not consider the impact of the float loss within the noncritical activities when the project duration is being crashed. The new framework allows project managers to exercise new trade-offs between time, cost and risk which will ultimately improve the chances of achieving project objectives.

The purpose of this paper is twofold. First and most importantly, the paper aims to explain how Pilkington is able to revolutionize the flat glass industry. The modified design envelope model is applied to demonstrate the technological competence and especially strategic thinking concerning to understanding of the markets and positioning the product. Second, the paper demonstrates the entrepreneurship within a large‐scale manufacturing firm.

The paper applies a longitudinal, historical, and contextual approach. The paper uses multiple case study method and multiple data sources. This is done because creation of an innovation does not take place in vacuum, it is context bound.

The float glass fulfills the requirements of two industries: the plate and sheet glasses. Within both industries, short‐sighted competitors concentrate on technologies applicable only in other industry. Pilkington positions the float glass first clearly in the plate glass industry and after further development introduces the technology to sheet glass industry as a total surprise. Based on the case, the paper argues that positioning should be part of the corporate strategy.

In addition to complex systematic technologies, the example shows that the design envelope model is applicable also for simple non‐assembled products like flat glass. The model is useful for companies to build scenarios for responses if new unexpected innovations will be introduced in its own or related industries.

This paper offers a novel insight to the old but still viable case of dominant design. In addition, the thorough case description allows reader to go deeply into a classic example of process innovation.

Tells a personal story of building a plane with floats. Includes technical details and a description of performance on high‐altitude lakes, along with assessors' comments.

The rate of urbanization and its implications in post‐Mao China have been underestimated in most recent studies on China’s urbanization as they have excluded the rising urban floating population. Making use of recently available floating population survey data assesses the significance of China’s urban floating population and its socio‐economic consequences and suggests remedial measures to control its flow. Finds that the floating population caused China to experience one of the highest urban population growths among the developing countries. The floating population has increased rural‐urban labour mobility and helped to eliminate the dualistic nature of Chinese society. But it has also caused oveer‐urbanization and environmental pollution and created certain social problems. To control the flow of the urban floating population, argues that the government should increasingly rely on indirect market‐based control mechanisms.

This paper aims to identify how non-financial firms manage their interest rate (IR) exposure. IR risk is complex, as it comprises the unequal cash flow and fair value risk. The paper is able to separate both risk types and investigate empirically how the exposure is composed and managed, and whether firms increase or decrease their exposure with derivative transactions.

The paper examines an unexplored regulatory environment that contains publicly reported IR exposure data on the firms’ exposures before and after hedging. The data were complemented by indicative interviews with four treasury executives of major German corporations, including two DAX-30 firms, to include professional opinions to validate the results.

The paper provides new empirical insights about how non-financial firms manage their interest rate exposure. It suggests that firms use hedging instruments to swap from fixed- to floating-rate positions predominantly in the short-to medium-term, and that 63 [37] per cent of IR firm exposure are managed using risk-decreasing [risk-increasing/-constant] strategies.

Interviewed treasury executives suggest that the advanced disclosures benefit various stakeholders, ranging from financial analysts and shareholders to potential investors through more meaningful analyses on firms’ risk management activities. Further, the treasury executives indicate that the new data granularity would enable firms to carry out unprecedented competitive analyses and thereby benchmark and improve their own risk management.

The paper is the first empirical study to analyze the interest rate activities of non-financial firms based on actually reported exposure data before and after hedging, rather than using proxy variables. In addition, the new data granularity enables a separate analysis of the cash flow and fair value risk to focus on the non-financial firms’ requirements.

The purpose of this paper is to empirically analyse how different exchange rate regimes affect the links between monetary fundamentals and exchange rates in Sub-Saharan Africa.

Using the Pedroni method for panel cointegration, mean group and pooled mean group and the panel vector autoregressive technique, this study empirically investigates whether monetary fundamentals impact exchange rates similarly in both regimes. Thus, the author acquires needed and credible empirical data.

The result suggests that the impact is dissimilar. In the floating regime, an increase in relative money supply and relative real output depreciates and appreciates the nominal exchange rate in the long run whereas in the non-floating regime, the evidence is mixed. Thus, exchange rates bear a theoretically consistent relationship with monetary fundamentals across SSA countries with floating regimes but fails under non-floating regimes. This provides evidence that regime choice is important if the relationship between monetary fundamentals and exchange rates in SSA are to be theoretically consistent.

This study empirically incorporates the dissimilarities in exchange rate regimes in a panel framework and study the links between exchange rates and monetary fundamentals. The focus on how exchange rate regimes might alter the equilibrium relationships between exchange rates and monetary fundamentals in SSA is a pioneering experiment.