Essemtec introduces Traqu, a high-resolution digital 3D inspection device used for 3D measurement and analysis in processes such as solder paste inspection

Soldering & Surface Mount Technology

ISSN: 0954-0911

Article publication date: 20 September 2011

Citation

(2011), "Essemtec introduces Traqu, a high-resolution digital 3D inspection device used for 3D measurement and analysis in processes such as solder paste inspection", Soldering & Surface Mount Technology, Vol. 23 No. 4. https://doi.org/10.1108/ssmt.2011.21923daa.013

Publisher

:

Emerald Group Publishing Limited

Copyright © 2011, Emerald Group Publishing Limited


Essemtec introduces Traqu, a high-resolution digital 3D inspection device used for 3D measurement and analysis in processes such as solder paste inspection

Article Type: New products From: Soldering & Surface Mount Technology, Volume 23, Issue 4

Traqu is a high-resolution digital 3D inspection device from Essemtec used for 3D measurement and analysis in processes such as solder paste inspection (SPI). Measurement tasks are programmed with a few mouse clicks, and DXF and Gerber data can be imported.

Traqu is not a traditional AOI but rather a 3D inspection system for process optimization, monitoring and sample control. The infrared-interferometric sensor scans any 3D structure, independent of material and surface. Depending on installed lenses, vertical resolution from 2 to 200 nm and a horizontal resolution from 1 to 20 μm can be achieved.

Traqu applications are versatile. In electronics production, Traqu is used for SPI and quality insurance for stencil printers. Solar cell manufacturers can measure the cross-section of bars and fingers. LED manufacturers can measure the form and volume of dispensed lenses. Traqu can analyze any 3D surface as well as measure coating thickness.

Programming and analysis are simple due to the simple Traqu software. The substrate layout is either imported from DXF or Gerber data or taught in manually. The scan area is marked by drawing a box around it with the mouse. For PCB inspection, Traqu can be set to automatically scan all packages of the same type.

The desired type of analysis, measurement, calculation and result display is stored in a recipe for later reuse. The area of inspection covers 300×400 mm. Additionally, a flexible magnetic holder is integrated for any substrate type.