Inter-bead void reduction by crossing printing routes of fused filament fabricated composites
ISSN: 1355-2546
Article publication date: 26 April 2024
Issue publication date: 17 May 2024
Abstract
Purpose
The use of continuous fiber-reinforced filaments improves the mechanical properties obtained with the fused filament fabrication (FFF) process. Yet, there is a lack of simulation tailored tools to assist in the design for additive manufacturing of continuous fiber composites. To build such models, a precise elastic model is required. As the porosity caused by interbead voids remains an important flaw of the process, this paper aims to build an elastic model integrating this aspect.
Design/methodology/approach
To study the amount of porosity, which could be a failure initiator, this study proposes a two step periodic homogenization method. The first step concerns the microscopic scale with a unit cell made of fiber and matrix. The second step is at the mesoscopic scale and combines the elastic material of the first step with the interbead voids. The void content has been set as a parameter of the model. The material models predicted with the periodic homogenization were compared with experimental results.
Findings
The comparison between periodic homogenization results and tensile test results shows a fair agreement between the experimental results and that of the numerical simulation, whatever the fibers’ orientations are. Moreover, a void content reduction has been observed by increasing the crossing angle from one layer to another. An empiric law giving the porosity according to this crossing angle was created. The model and the law can be further used for design evaluation and optimization of continuous fiber-reinforced FFF.
Originality/value
A new elastic model considering interbead voids and its variation with the crossing angle of the fibers has been built. It can be used in simulation tools to design high performance fused filament fabricated composite parts.
Keywords
Acknowledgements
Declaration of competing interest: The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.
CrediT author statement: Valentin Marchal: conceptualization; methodology; software; formal analysis; investigation; data curation; writing – original draft; writing – review and editing; visualization; Yicha Zhang: conceptualization; writing – review and editing; funding acquisition; supervision; Rémy Lachat: methodology; validation; investigation; writing – review and editing; Nadia Labed: conceptualization; methodology; formal analysis; writing – review and editing; supervision; François Peyraut: conceptualization; methodology; software; formal analysis; data curation; writing – original draft; writing – review and editing; supervision.
Citation
Marchal, V., Zhang, Y., Lachat, R., Labed, N. and Peyraut, F. (2024), "Inter-bead void reduction by crossing printing routes of fused filament fabricated composites", Rapid Prototyping Journal, Vol. 30 No. 5, pp. 1000-1010. https://doi.org/10.1108/RPJ-02-2024-0077
Publisher
:Emerald Publishing Limited
Copyright © 2024, Emerald Publishing Limited