To read this content please select one of the options below:

Predicting hot wire tungsten inert gas welding parameters for joining P91 and 304HCu steel using multi-optimization techniques

Sashank Sravan (Department of Manufacturing Engineering, Annamalai University, Chidambaram, India)
S. Rajakumar (Department of Manufacturing Engineering, Annamalai University, Chidambaram, India)
Karthikeyan Rajagopalan (Department of Mechanical Engineering, Gokaraju Rangaraju Institute of Engineering and Technology, Hyderabad, India)
Kavitha Subramanian (Department of Electronics and Instrumentation Engineering, Annamalai University, Chidambaram, India)

Multidiscipline Modeling in Materials and Structures

ISSN: 1573-6105

Article publication date: 28 February 2023

Issue publication date: 20 April 2023

71

Abstract

Purpose

Dissimilar joining of austenitic stainless steels and ferritic steels is a challenging task and has a wide range of applications due to its excellent mechanical and thermal characteristics. They are joined mostly by using conventional modes. In the current investigation, the study and optimization of hot wire TIG welding parameters was carried out.

Design/methodology/approach

These parameters will govern the desired characteristics of the joint. Solutions were found out through multi-response optimization by using response surface methodology and single response optimization using particle swarm optimization.

Findings

Optimized input welding parameters that were achieved are electrode current 180 amps, wire feed rate 1870 mm/min and hot wire current 98 amps and the optimized UTS is 665.45 MPa. The results from PSO were compared with RSM and the optimized input welding parameters for the electrode current, hot wire current and wire feed rate exhibited maximum ultimate tensile strength which were also confirmed from response and contour plots.

Originality/value

Sensitivity analysis was also performed to understand the effect of each individual parameters on the response. Microstructure features were evaluated for the joints and was found that the characteristics are within the desired criteria.

Keywords

Citation

Sravan, S., Rajakumar, S., Rajagopalan, K. and Subramanian, K. (2023), "Predicting hot wire tungsten inert gas welding parameters for joining P91 and 304HCu steel using multi-optimization techniques", Multidiscipline Modeling in Materials and Structures, Vol. 19 No. 3, pp. 375-388. https://doi.org/10.1108/MMMS-10-2022-0233

Publisher

:

Emerald Publishing Limited

Copyright © 2023, Emerald Publishing Limited

Related articles