To read this content please select one of the options below:

Wetting Balance Methods for Component and Board Solderability Evaluation

K.M. Lin (AT&T Bell Laboratories, Princeton, New Jersey, USA)
F.H. Friend (AT&T Bell Laboratories, Princeton, New Jersey, USA)

Circuit World

ISSN: 0305-6120

Article publication date: 1 April 1989

50

Abstract

With the increased use of surface‐mounted devices, both the component density and the board complexity are greatly increased on many circuit pack assemblies. Good solderability for the components as well as for the printed circuit boards has become one of the most important elements in achieving the ultra‐high efficiency and quality required of an assembly soldering process in today's competitive environment. Solderability evaluation generally uses the ‘dip and look’ method that relies entirely on the individual inspectors' often inconsistent interpretations resulting from the examination of the specimen dip‐tested in a molten solder bath. This method is subjective, so the results can vary from person to person and from day to day. In addition, the sensitivity of such a method is inadequate in discerning the differences in solder wetting characteristics of very small device leads and terminations. Consequently, components with marginal or even bad solderability may pass through inspection and move onto the production line to cause many easily avoidable defects and their subsequent repairs. A sensitive and quantitative wetting balance method has been studied with the purpose of developing a better alternative to the ‘dip and look’ procedure. Special sample holders and test conditions have been developed for testing various types of components and printed circuit board coupons. Examples of solderability testings are provided to illustrate the capability of the instrument when proper testing procedures are followed. More effort is under way to simplify the test procedure, and to establish a practical solderability test standard for the wetting balance method.

Citation

Lin, K.M. and Friend, F.H. (1989), "Wetting Balance Methods for Component and Board Solderability Evaluation", Circuit World, Vol. 16 No. 1, pp. 24-32. https://doi.org/10.1108/eb046066

Publisher

:

MCB UP Ltd

Copyright © 1989, MCB UP Limited

Related articles