A New Needle Bearing

Aircraft Engineering and Aerospace Technology

ISSN: 0002-2667

Publication date: 1 June 1939

Abstract

ONE of the objections attendant on the use of needle roller bearings, as illustrated in Fig. 1, has been overcome by the introduction of needle rollers having trunnion instead of spherical ends. In the type shown in Fig. 1, without adding considerably to the cost of the bearing, it is only with difficulty that the rollers can be kept in position during the process of fitting, whereas with the design illustrated in Fig. 2, by the employment of rollers having trunnion ends, they can be readily retained in the outer ring by means of pressings fitted into the bore of the shoulders, thus enabling the outer ring and rollers to be handled as a single unit during fitting.

Citation

(1939), "A New Needle Bearing", Aircraft Engineering and Aerospace Technology, Vol. 11 No. 6, pp. 254-254. https://doi.org/10.1108/eb030503

Download as .RIS

Publisher

:

MCB UP Ltd

Copyright © 1939, MCB UP Limited

Please note you might not have access to this content

You may be able to access this content by login via Shibboleth, Open Athens or with your Emerald account.
If you would like to contact us about accessing this content, click the button and fill out the form.
To rent this content from Deepdyve, please click the button.