Experimental investigation of FDM process for improvement of mechanical properties and production cost

Abstract

Purpose

The mechanical properties and surface finish of functional parts are important consideration in rapid prototyping, and the selection of proper parameters is essential to improve manufacturing solutions. The purpose of this paper is to describe how parts manufactured by fused deposition modelling (FDM), with different part orientations and raster angles, were examined experimentally and evaluated to achieve the desired properties of the parts while shortening the manufacturing times due to maintenance costs.

Design/methodology/approach

For this purpose, five different raster angles (0°, 30°, 45°, 60° and 90°) for three part orientations (horizontal, vertical and perpendicular) have been manufactured by the FDM method and tested for surface roughness, tensile strength and flexural strength. Also, behaviour of the mechanical properties was clarified with scanning electron microscopy images of fracture surfaces.

Findings

The research results suggest that the orientation has a more significant influence than the raster angle on the surface roughness and mechanical behaviour of the resulting fused deposition part. The results indicate that there is close relationship between the surface roughness and the mechanical properties.

Originality/value

The results of this paper are useful in defining the most appropriate raster angle and part orientation in minimum production cost for FDM components on the basis of their expected in-service loading.

Citation

Durgun, I. and Ertan, R. (2014), "Experimental investigation of FDM process for improvement of mechanical properties and production cost", Rapid Prototyping Journal, Vol. 20 No. 3, pp. 228-235. https://doi.org/10.1108/RPJ-10-2012-0091