Dynamic resolution control in a laser projection-based stereolithography system

Abstract

Purpose

In a typical additive manufacturing (AM) system, it is critical to make a trade-off between the resolution and the build area for applications in which varied dimensions, feature sizes and accuracies are desired. Conventional solutions to this challenge are based on curing of multiple areas with a single high resolution and stitching them to form a large layer. However, because of the lack of the capability in adjusting resolution dynamically, such stitching approaches will elongate the build time greatly in some cases. To address the challenge without sacrificing the build speed, this paper aims to design and develop a novel AM system with dynamic resolution control capability.

Design/methodology/approach

A laser projector is adopted in a vat photopolymerization system. The laser projection system has unique properties, including focus-free operation and capability to produce dynamic mask image irrespective of any surface (flat or curved). By translating the projector along the building direction, the pixel size can be adjusted dynamically within a certain range. Consequently, the build area and resolution could be tuned dynamically in the hardware testbed. Besides, a layered depth image (LDI) algorithm is used to construct mask images with varied resolutions. The curing characteristics under various resolution settings are quantified, and accordingly, a process planning approach for fabricating models with dynamically controlled resolutions is developed.

Findings

A laser projection-based stereolithography (SL) system could tune resolution dynamically during the building process. Such a dynamic resolution control approach completely addresses the build size-resolution dilemma in vat photopolymerization AM processes without sacrificing the build speed. Through fabricating layers with changing resolutions instead of a single resolution, various build areas and feature sizes could be produced precisely, with optimized build speed.

Originality/value

A focus-free laser projector is investigated and adopted in a SL system for the first time. The material curing characteristics with changing focal length and therefore changing light intensities are explored. The related digital mask image planning and process control methods are developed. In digital mask image planning, it is the first attempt to adopt the LDI algorithm, to identify proper resolution settings for fabricating a sliced layer precisely and quickly. In the process of characterizing material curing properties, parametric dependence of curing properties on focal length has been unveiled. This research contributes to the advancement of AM by addressing the historical dilemma of the resolution and build size, and optimizing the build speed meanwhile.

Citation

Pan, Y. and Dagli, C. (2017), "Dynamic resolution control in a laser projection-based stereolithography system", Rapid Prototyping Journal, Vol. 23 No. 1, pp. 190-200. https://doi.org/10.1108/RPJ-08-2015-0113