Rapid tooling using friction stir welding and machining

Abstract

Purpose

This paper aims to present a friction stir molding (FSM) method for the rapid manufacturing of metal tooling. The method uses additive and subtractive techniques to sequentially friction stir bond and then mill slabs of metal. Mold tooling is grown in a bottom-up fashion, overcoming machining accessibility problems typically associated with deep cavity tooling.

Design/methodology/approach

To test the feasibility of FSM in building functional molds, a layer addition procedure that combines friction stir spot welding (FSSW) with an initial glue application and clamping for slabs of AA6061-T651 was investigated. Additionally, FSSW parameters and the mechanical behavior of test mold materials, including shear strength and hardness, were studied. Further, scanning electron microscopy (SEM)/elemental map analysis (EDS) of the spot weld zones was carried out to understand the effect of FSSW on the glue materials and to study potential mixing of glue with the plate materials in the welded zone.

Findings

The results indicate that FSM provides good layer stacking without gaps when slabs are pre-processed through sand blasting, moistening, uniform clamping and FSSW using a tapered pin tool. The tensile shear strength results revealed that the welded spots were able to withstand cutting forces during machining stages; however, FSSW was found to cause hardness reduction among spot zones because of over-aging. The SEM/EDS results showed that glue was not mixed with slab materials in spot zones. The proposed process was able to build a test tooling sample successfully using AA6061-T651 plates welded and machined on a three-axis computer numerical control (CNC) mill.

Originality/value

The proposed FSM process is a new process presented by the authors, developed for the rapid manufacturing of metal tooling. The method uses additive and subtractive techniques to sequentially friction stir bond and then mill slabs of metal. The use of FSSW process for materials addition is an original contribution that enables automatic process planning for this new process.

Citation

Abdel-All, E.S., Frank, M.C. and Rivero, I.V. (2017), "Rapid tooling using friction stir welding and machining", Rapid Prototyping Journal, Vol. 23 No. 1, pp. 81-95. https://doi.org/10.1108/RPJ-08-2015-0107