Effect of cold vapour treatment on geometric accuracy of fused deposition modelling parts

Abstract

Purpose

The purpose of this paper is to investigate the influence of low-cost chemical vapour treatment process on geometric accuracy and surface roughness of different curved and freeform surfaces of fused deposition modelling (FDM) specimens build at different part building orientations.

Design/methodology/approach

Parts with different primitive and curved surfaces are designed and modelled to build at three different part orientations along X orientation (vertical position resting on side face), Y orientation (horizontal position resting on base) and Z orientation (upright position). Later, the parts are post-processed by cold vapours of acetone. Geometric accuracy and surface roughness are measured both before and after the chemical treatment to investigate the change in geometric accuracy, surface roughness of FDM parts.

Findings

The results indicate that surface roughness is reduced immensely after cold vapour treatment with minimum variation in geometric accuracy of parts. Parts build vertically over its side face (X orientation) provides the overall better surface finish and geometric accuracy.

Originality/value

The present study provides an approach of post-built treatment for FDM parts and observes a significant improvement in surface finish of the components. The present approach of post-built treatment can be adopted to enhance the surface quality as well as to achieve desired geometric accuracy for different primitive, freeform/curved surfaces of FDM samples suitable for functional components as well as prototypes.

Citation

Garg, A., Bhattacharya, A. and Batish, A. (2017), "Effect of cold vapour treatment on geometric accuracy of fused deposition modelling parts", Rapid Prototyping Journal, Vol. 23 No. 6, pp. 1226-1236. https://doi.org/10.1108/RPJ-05-2016-0072