Serial robotic plasma additive manufacturing on complex NURBS surface
ISSN: 0143-991x
Article publication date: 13 September 2022
Issue publication date: 17 February 2023
Abstract
Purpose
This paper aims to investigate the additive manufacturing (AM) approach of a spatial complex curve feature (SCCF, mapped from two-dimensional nonuniform rational B-splines [2D-NURBS] curve) on a complex surface based on a serial robot using plasma built-up welding, and lays a foundation for plasma AM SCCFs on complex surfaces by combining the NURBS theory with the serial robotic kinematics.
Design/methodology/approach
Combining serial robotic kinematics and NURBS theory, a SCCF mapped from a square-like 2D-NURBS curve is prepared on a predefined complex NURBS surface using serial robotic plasma AM. The interpolation points C (ui) on the square-like 2D-NURBS curve are obtained using the equi-chord length interpolation method, and mapped on a predefined NURBS surface to get mapped points S (ui, vj). The homogeneous transformation matrix T = [n o a S (ui, vj)] of the plasma torch is calculated using the mapped points S (ui, vj) and the designated posture [n o a]. Using the inverse kinematics of the serial robot, the joint vector θ of the serial robot can be computed. After that, the AM programs are generated and transferred into the serial robotic controller and carried out by the serial robot of Motoman-UP6. The 2D-NURBS curve (square-like) is considered as AM trajectory planning curve, while its corresponding SCCF mapped from the 2D-NURBS curve as AM trajectory.
Findings
Simulation and experiments show that the preparation of SCCF (mapped from 2D-NURBS curve) on complex NURBS surface using robotic plasma AM is feasible and effective.
Originality/value
A SCCF mapped from a 2D-NURBS curve is prepared on a complex NURBS surface using the serial robotic plasma AM for the first time. It provides a theoretical and technical basis for plasma AM to produce SCCFs on complex surfaces. With the increasing demand for surface remanufacturing of complex parts, the serial robotic plasma AM of SCCFs on complex NURBS surfaces has a broad application prospect in aero-engine components, high-speed rail power components, nuclear industry components and complex molds.
Keywords
Acknowledgements
This work was supported by the National Natural Science Foundation of China (Grant Nos. 52075235 and 51764038), Gansu Provincial Department of Education: Industrial Support Plan Project (Grant No. 2022CYZC-31), the Employee Innovation Subsidy Fund Project of All China Federation of Trade Unions, Open Project of State Key Laboratory of Advanced Welding and Joining (Grant No. AWJ-21Z02), Gansu Science and Technology Planning Project (Grant Nos. 20YF8GA033, 20YF3FA040, 17YF1GA018, 17CX1JA117 and 18JR3RA132), Western Young Scholars of Chinese Academy of Sciences, Lanzhou Talent Innovation and Entrepreneurship Project (Grant Nos. 2020-RC-120, 2019-RC-102 and 2018-RC-108), Longyuan Youth Innovative and Entrepreneurial Talents Project, Foundation of A Hundred Youth Talents Training Program of Lanzhou Jiaotong University and Gansu Provincial Employee Technology Innovation Subsidy Fund Project.
Citation
Wang, Z., Shi, Y. and Wang, X. (2023), "Serial robotic plasma additive manufacturing on complex NURBS surface", Industrial Robot, Vol. 50 No. 2, pp. 246-255. https://doi.org/10.1108/IR-04-2022-0097
Publisher
:Emerald Publishing Limited
Copyright © 2022, Emerald Publishing Limited