To read this content please select one of the options below:

A stepping gait trajectory design based on hip height variation of swing leg for the balance of lower extremity exoskeleton

Canjun Yang (Department of Mechanical Engineering, State Key Laboratory of Fluid Power Transmission and Control, Hangzhou, China)
Hansong Wang (Zhejiang University, Hangzhou, China)
Qihang Zhu (Zhejiang da xue, Hangzhou, China)
Xiangzhi Liu (Zhejiang da xue, Hangzhou, China)
Wei Yang (Department of Mechanical Engineering, Zhejiang University, Hangzhou, China)
Zhangyi Ma (Zhejiang University School of International Studies, Hangzhou, China)
Qianxiao Wei (Department of Mechanical Engineering, Zhejiang University – Yuquan Campus, Hangzhou, China)

Industrial Robot

ISSN: 0143-991x

Article publication date: 26 November 2019

Issue publication date: 23 March 2020

243

Abstract

Purpose

Lower extremity exoskeletons have drawn much attention recently due to their potential ability to help the stroke and spinal cord injury patients to regain the ability of walking. However, the balance of the human-exoskeleton system (HES) remains a big challenge. Usually, patients use crutches to keep balance when they wear exoskeleton. However, the balance depends greatly on the patient's balance ability and will be inevitably poor occasionally, which often causes the landing in advance of HES. The purpose of this paper is to propose a real-time stepping gait trajectory planning method based on the hip height variation of the swing leg to solve the problem.

Design/methodology/approach

The hip height of the swing leg was analyzed and measured. The simulation with MATLAB and the experimental test with the prototype of the proposed gait were conducted to verify its feasibility.

Findings

With the proposed method, HES can achieve successful step even when the balance kept by crutches is poor.

Research limitations/implications

Instead of actively avoiding the poor balance due to the instability caused by gravity, the method just modifies the stepping gait passively to avoid the landing in advance when the poor balance appears. In addition, it may not work well when the balance is too poor. Moreover, the proposed gait is just used in the initial stage of rehabilitation training. Besides, the step length of the gait must be limited for comfort.

Originality/value

A real-time stepping gait trajectory planning method based on the hip height variation of the swing leg is first proposed and its feasibility to avoid the landing in advance when the balance kept by the crutches is poor has been preliminary verified.

Keywords

Citation

Yang, C., Wang, H., Zhu, Q., Liu, X., Yang, W., Ma, Z. and Wei, Q. (2020), "A stepping gait trajectory design based on hip height variation of swing leg for the balance of lower extremity exoskeleton", Industrial Robot, Vol. 47 No. 2, pp. 281-292. https://doi.org/10.1108/IR-01-2019-0024

Publisher

:

Emerald Publishing Limited

Copyright © 2019, Emerald Publishing Limited

Related articles