Numerical simulation of the effect of using nanofluid in phase change process of cooling fluid

Abstract

Purpose

The purpose of this paper is to numerically simulate the nanofluid boiling inside a tube in turbulent flow regime and to investigate the effect of adding volume faction of CuO nanoparticles on the boiling process.

Design/methodology/approach

To make sure the accuracy of the obtained numerical results, the results of this paper have been compared with the experimental results and an acceptable coincidence has been achieved. In the current paper, by Euler–Euler method, the phase change of boiling phenomenon has been modeled. The presented results are the local Nusselt number distribution, temperature distribution of wall, the distribution of volume fraction of vapor phase and fluid temperature at the center of the tube.

Findings

The obtained results indicate that using nanofluid is very effective in the postponement of the boiling process. Hence, by change the amount of volume fraction of nanoparticles in base fluid, the location of phase change and bubble creation are changed. Also, at the Reynolds numbers of 50,000, 100,000 and 150,000 with the volume fraction of 2 per cent, the beginning locations of phase change process are, respectively, 2D, 10D and 13D, and for the volume fraction of 4 per cent, the beginning locations of phase change are 4D, 18D and 19D, respectively. These results indicate that, as the volume fraction of nanoparticles increases, the location of the start of the phase change process is postponed that this issue causes the increment of heat transfer from wall to fluid and the reduction of wall temperature. In general, it can be stated that, in boiling flows, using nanofluid because of the delay in boiling phenomenon has a good effect on heat transfer enhancement of heated walls. Also, the obtained results show that, by increasing Reynolds number, the created vapor phase reduces that leads to increase of the Nusselt number.

Originality/value

The paper investigates the effect of using nanofluid in phase change process of cooling fluid.

Citation

Pourfattah, F., Yousefi, S., Akbari, O.A., Adhampour, M., Toghraie, D. and Hekmatifar, M. (2020), "Numerical simulation of the effect of using nanofluid in phase change process of cooling fluid", International Journal of Numerical Methods for Heat & Fluid Flow, Vol. 30 No. 6, pp. 2913-2934. https://doi.org/10.1108/HFF-12-2018-0806