TY  - JOUR
AB  - Purpose In the present study, laminar steady flow of nanofluid through a trapezoidal channel is studied by using of finite volume method. The main aim of this paper is to study the effect of changes in geometric parameters, including internal and external dimensions on the behavior of heat transfer and fluid flow. For each parameter, an optimum ratio will be presented.Design/methodology/approach The results showed that in a channel cell, changing any geometric parameter may affect the temperature and flow field, even though the volume of the channel is kept constant. For a relatively small hydraulic diameter, microchannels with different angles have a similar dimensionless heat flux, while channels with bigger dimensions show various values of dimensionless heat flux. By increasing the angles of trapezoidal microchannels, dimensionless heat flux per unit of volume increases. As a result, the maximum and minimum heat transfer rate occurs in a trapezoidal microchannel with 75° and 30 internal’s, respectively. In the study of dimensionless heat flux rate with hydraulic diameter variations, an optimum hydraulic diameter (Dh) was observed in which the heat transfer rate per unit volume attains maximum value.Findings This optimum state is predicted to happen at a side angle of 75° and hydraulic diameter of 290 µm. In addition, in trapezoidal microchannel with higher aspect ratio, dimensionless heat flux rate is lower. Changing side angles of the channels and pressure drop have the same effect on pressure drop. For a constant pressure drop, if changing the side angles causes an increase in the rectangular area of the channel cross-section and the effect of the sides are not felt by the fluid, then the dimensionless heat flux will increase. By increasing the internal aspect ratio (t_2/t_3), the amount of t_3 decreases, and consequently, the conduction resistance of the hot surface decreases.Originality/value The effects of geometry of the microchannel, including internal and external dimensions on the behavior of heat transfer and fluid flow for pressure ranges between 2 and 8 kPa.
VL  - 29
IS  - 5
SN  - 0961-5539
DO  - 10.1108/HFF-05-2018-0231
UR  - https://doi.org/10.1108/HFF-05-2018-0231
AU  - Bakhshi Hesam
AU  - Khodabandeh Erfan
AU  - Akbari Omidali
AU  - Toghraie Davood
AU  - Joshaghani Mohammad
AU  - Rahbari Alireza
PY  - 2018
Y1  - 2018/01/01
TI  - Investigation of laminar fluid flow and heat transfer of nanofluid in trapezoidal microchannel with different aspect ratios
T2  - International Journal of Numerical Methods for Heat & Fluid Flow
PB  - Emerald Publishing Limited
SP  - 1680
EP  - 1698
Y2  - 2024/04/25
ER  -