To read this content please select one of the options below:

Brownian models effect on turbulent fluid flow and heat transfer and entropy generation of water/boehmite alumina nanofluid inside enclosure

Behrouz Mozafari (Department of Mechanical Engineering, Arak Branch, Islamic Azad University, Arak, Iran)
Ali Akbar Abbasian Arani (Department of Mechanical Engineering, University of Kashan, Kashan, Iran)
Ghanbar Ali Sheikhzadeh (Department of Mechanical Engineering, University of Kashan, Kashan, Iran)
Mahmoud Salimi (Department of Mechanical Engineering, Arak Branch, Islamic Azad University, Arak, Iran)

International Journal of Numerical Methods for Heat & Fluid Flow

ISSN: 0961-5539

Article publication date: 17 June 2019

Issue publication date: 30 April 2020

54

Abstract

Purpose

The purpose of this paper is to study the effects of using different Brownian models on natural and mixed convection fluid flow and heat transfer inside the square enclosure filled with the AlOOH–water nanofluid.

Design/methodology/approach

Due to fulfill of this demand, five different models for the effective thermal conductivity and viscosity of the nanofluid are considered. The following results are presented for the Ra=107 to 1010 and Ri=0.01 to 100, whereas the volume fraction of the nanoparticles is varied from φ = 0.01 to 0.04.

Findings

According to the obtained results, increasing of Rayleigh number and reduction of Richardson number leads to the higher values of the average Nusselt number and entropy generation. Also, it is realized that, variation trend of the average Nusselt number and entropy generation in all cases is increasing by growing the volume fraction. It is found that the obtained average Nusselt numbers and entropy generations with Koo and Kleinstreuer are the highest among all the studied cases, and it is followed by Patel, Vajjha and Das, Corcione and Maxwell–Brinkman models, respectively.

Originality/value

Based on the results of present investigation, the Nusselt number difference predicted between the Maxwell–Brinkman model (as constant-property model) and Koo and Kleinstreuer model is about 7.84 per cent at 0.01 per cent volume fraction and 5.47 per cent at 0.04 per cent volume fraction for the Rayleigh number equal to 107. The entropy generation difference predicted between the two above studied model is about 8.05 per cent at 0.01 per cent volume fraction and 5.86 per cent at 0.04 per cent volume fraction for the Rayleigh number equal to 107. It is observed that using constant-property model has a significant difference in the obtained results with the results of other variable-property models.

Keywords

Citation

Mozafari, B., Abbasian Arani, A.A., Sheikhzadeh, G.A. and Salimi, M. (2020), "Brownian models effect on turbulent fluid flow and heat transfer and entropy generation of water/boehmite alumina nanofluid inside enclosure", International Journal of Numerical Methods for Heat & Fluid Flow, Vol. 30 No. 5, pp. 2305-2327. https://doi.org/10.1108/HFF-01-2019-0050

Publisher

:

Emerald Publishing Limited

Copyright © 2019, Emerald Publishing Limited

Related articles