To read this content please select one of the options below:

Influence of non-linear frequency-dependent material properties on the operation of rotating electrical machines

Andreas Ruf (Institute of Electrical Machines, RWTH Aachen University, Aachen, Germany)
Simon Steentjes (Institute of Electrical Machines, RWTH Aachen University, Aachen, Germany)
David Franck (Institute of Electrical Machines, RWTH Aachen University, Aachen, Germany)
Kay Hameyer (Institute of Electrical Machines, RWTH Aachen University, Aachen, Germany)

Abstract

Purpose

The purpose of this paper is to focus on the frequency-dependent non-linear magnetization behaviour of the soft magnetic material, which influences both the energy loss and the performance of the electrical machine. The applied approach is based on measured material characteristics for various frequencies and magnetic flux densities. These are varied during the simulation according to the operational conditions of the rotating electrical machine. Therewith, the fault being committed neglecting the frequency-dependent magnetization behaviour of the magnetic material is examined in detail.

Design/methodology/approach

The influence of non-linear frequency-dependent material properties is studied by variation of the frequency-dependent magnetization characteristics. Two different non-oriented electrical steel grades having the same nominal losses at 1.5 T and 50 Hz, but different thickness, classified as M330-35A and M330-50A are studied in detail. Both have slightly different magnetization and loss behaviour.

Findings

This analysis corroborates that it is important to consider the frequency-dependency and saturation behaviour of the ferromagnetic material as well as its magnetic utilization when simulating electrical machines, i.e., its performance. The necessity to change the magnetization curve according to the applied frequency for the calculation of operating points depends on the applied material and the frequency range. Using materials, whose magnetization behaviour is marginally affected by frequency, causes a deviation in the flux-linkage and the electromagnetic torque in a small frequency range. However, analysing larger frequency ranges, the frequency behaviour of the material cannot be neglected. For instance, a poorer magnetizability requires a higher quadrature current to keep the same torque leading to increased copper losses. In addition, the applied iron-loss model plays a central role, since changes in magnetization behaviour with frequency lead to changes in the iron losses. In order to study the impact, the iron-loss model has to be capable to incorporate the harmonic content, because particularly the field harmonics are influenced by the shape of the magnetization curve.

Originality/value

This paper gives a close insight on the way the frequency-dependent non-linear magnetization behaviour affects the energy loss and the performance of electrical machines. Therewith measures to tackle this could be derived.

Keywords

Acknowledgements

The results presented in this paper have been developed in a research project granted by the Federal Ministry for Economic Affairs and Energy with the reference number 01MY12006A.

Citation

Ruf, A., Steentjes, S., Franck, D. and Hameyer, K. (2015), "Influence of non-linear frequency-dependent material properties on the operation of rotating electrical machines", COMPEL - The international journal for computation and mathematics in electrical and electronic engineering, Vol. 34 No. 3, pp. 674-690. https://doi.org/10.1108/COMPEL-10-2014-0265

Publisher

:

Emerald Group Publishing Limited

Copyright © 2015, Emerald Group Publishing Limited

Related articles