Influence of milling toolpaths in machining of the turbine blade

Abstract

Purpose

The purpose of this paper is to machine the pressure surface of the turbine blade made of A286 iron-based superalloy by using four directions of raster strategy, including horizontal upward, horizontal downward, vertical upward and vertical downward, to achieve appropriate surface roughness and to investigate the tool wear in each strategy.

Design/methodology/approach

In this study, all cutting tests were performed by DAHLIH-MCV 1020 BA vertical 3-axis machining center with ball nose end mill. After milling by each strategy, according to the surface slope, the surface was divided into 27 meshes, and roughness of surface was studied and compared. Roughness measuring after machining was implemented by using portable Mahr ps1 roughness tester, and surface texture was photographed by CCD 100× optical zoom camera. Also, to measure tool flank wear in each strategy as an indication of tool life, the surface of workpiece was divided into four equal areas. The wear of the inserts was measured by ARCS vertical non-contact measuring system at the end of each area.

Findings

The results indicate that cutting directions and toolpath strategies have significant influence on tool wear and surface roughness in machining processes and that they can be taken into consideration individually as determinative parameters. In this case, the most uniform surface texture and the lowest surface roughness are obtained by using horizontal downward direction; in addition, abrasion is a dominant tool wear mechanism in all experiments, and tool wear in the horizontal downward is lower than other strategies.

Practical implications

Machining of turbine blades or other airfoil-shaped workpieces is quite common in manufacturing aerospace and aircraft products. The results of this research contribute to increasing quality of machined surface and tool life in machining of turbine blade.

Originality/value

This work proves the significance of milling strategies in machining of the turbine blade made of A286 superalloy and, consequently, exhibits the proper strategy in terms of surface roughness and tool life. Also, this work explains and elaborates the behavior of A286 superalloy in machining processes, which has not been studied much in recent research works.

Citation

Jarolmasjed, S., Davoodi, B. and Pourebrahim Alamdari, B. (2019), "Influence of milling toolpaths in machining of the turbine blade", Aircraft Engineering and Aerospace Technology, Vol. 91 No. 10, pp. 1327-1339. https://doi.org/10.1108/AEAT-12-2018-0316