To read this content please select one of the options below:

Results of simulation and scaled flight tests performed on a rocket-plane at high angles of attack

Agnieszka Kwiek (Institute of Aeronautics and Applied Mechanics, Warsaw University of Technology, Warsaw, Poland)
Cezary Galinski (Institute of Aeronautics and Applied Mechanics, Warsaw University of Technology, Warsaw, Poland)
Krzysztof Bogdański (Institute of Aeronautics and Applied Mechanics, Warsaw University of Technology, Warsaw, Poland)
Jaroslaw Hajduk (Air Force Institute of Technology, Warsaw, Poland)
Andrzej Tarnowski (Institute of Aeronautics and Applied Mechanics, Warsaw University of Technology, Warsaw, Poland)

Aircraft Engineering and Aerospace Technology

ISSN: 0002-2667

Article publication date: 5 April 2021

Issue publication date: 11 November 2021

161

Abstract

Purpose

According to the study of the space flight market, there is a demand for space suborbital flights including commercial tourist flights. However, one of the challenges is to design a mission and a vehicle that could offer flights with relatively low G-loads. The project of the rocket-plane in a strake-wing configuration was undertaken to check if such a design could meet the FAA recommendation for this kind of flight. The project concept assumes that the rocket plane is released from a slowly flying carrier plane, then climbs above 100 kilometers above sea level and returns in a glide flight using a vortex lift generated by the strake-wing configuration. Such a mission has to include a flight transition during the release and return phases which might not be comfortable for passengers. Verification if FAA recommendation is fulfilled during these transition maneuvers was the purpose of this study.

Design/methodology/approach

The project was focused on the numerical investigation of a possibility to perform transition maneuvers mentioned above in a passenger-friendly way. The numerical simulations of a full-scale rocket-plane were performed using the simulation and dynamic stability analyzer (SDSA) software package. The influence of an elevator deflection change on flight parameters was investigated in two cases: a transition from the steep descent at high angles of attack to the level glide just after rocket-plane release from the carrier and an analogous transition after re-entry to the atmosphere. In particular, G-loads and G-rates were analyzed.

Findings

As a result, it was found that the values of these parameters satisfied the specific requirements during the separation and transition from a steep descent to gliding. They would be acceptable for an average passenger.

Research limitations/implications

To verify the modeling approach, a flight test campaign was performed. During the experiment, a rocket-plane scaled model was released from the RC model helicopter. The rocket-plane model was geometrically similar only. Froude scales were not applied because they would cause excessive technical complications. Therefore, a separate simulation of the experiment with the application of the scaled model was performed in the SDSA software package. Results of this simulation appeared to be comparable to flight test results so it can be concluded that results for the full-scale rocket-plane simulation are also realistic.

Practical implications

It was proven that the rocket-plane in a strake-wing configuration could meet the FAA recommendation concerning G-loads and G rates during suborbital flight. Moreover, it was proven that the SDSA software package could be applied successfully to simulate flight characteristics of airplanes flying at angles of attack not only lower than stall angles but also greater than stall angles.

Social implications

The application of rocket-planes in a strake-wing configuration could make suborbital tourist flights more popular, thus facilitating the development of manned space flights and contributing to their cost reduction. That is why it was so important to prove that they could meet the FAA recommendation for this kind of service.

Originality/value

The original design of the rocket plane was analyzed. It is equipped with an optimized strake wing and is controlled with oblique, all moving, wingtip plates. Its post-stall flight characteristics were simulated with the application of the SDSA software package which was previously validated only for angles of attack smaller than stall angle. Therefore, experimental validation was necessary. However, because of excessive technical problems caused by the application of Froude scales it was not possible to perform a conventional test with a dynamically scaled model. Therefore, the geometrically scaled model was built and flight tested. Then a separate simulation of the experiment with the application of this model was performed. Results of this separate simulation were compared with the results of the flight test. This comparison allowed to draw the conclusion on the applicability of the SDSA software for post-stall analyzes and, indirectly, on the applicability of the proposed rocket-plane for tourist suborbital flights. This approach to the experimental verification of numerical simulations is quite unique. Finally, a quite original method of the model launching during flight test experiment was applied.

Keywords

Acknowledgements

Special thanks to all numerous volunteers who helped in conducting this research but were not qualified as co-authors.

Funding: The building of the flying model and the flight test campaign was supported by ZONTA International Amelia Earhart Fellowship Program.

Citation

Kwiek, A., Galinski, C., Bogdański, K., Hajduk, J. and Tarnowski, A. (2021), "Results of simulation and scaled flight tests performed on a rocket-plane at high angles of attack", Aircraft Engineering and Aerospace Technology, Vol. 93 No. 9, pp. 1445-1459. https://doi.org/10.1108/AEAT-11-2020-0276

Publisher

:

Emerald Publishing Limited

Copyright © 2021, Emerald Publishing Limited

Related articles