To read this content please select one of the options below:

Effect of high temperature compression deformation strain rate on the microstructure and corrosion behavior of 2205 duplex stainless steel

Yinhui Yang (School of Materials Science and Engineering, Kunming University of Science and Technology, Kunming, China.)
Biao Yan (School of Materials Science and Engineering, Tongji University, Shanghai, China.)

Anti-Corrosion Methods and Materials

ISSN: 0003-5599

Article publication date: 5 May 2015

343

Abstract

Purpose

The aim of this paper was to investigate the effect of strain rate on microstructure and corrosion behavior of 2205 duplex stainless steel, after high-temperature compression tests.

Design/methodology/approach

The specimens were prepared using a Gleeble3800 thermo-simulation machine over a range of temperatures from 850 to 1,250°C and strain rates from 0.005 to 5 s−1, and the corresponding flow curves and deformation microstructure obtained were further analyzed. To evaluate the effect of strain rate on corrosion behavior, potentiodynamic polarization tests and double-loop electrochemical potentiodynamic reactivation (DL-EPR) were used to characterize the electrochemical performance.

Findings

Compared with strain rate of 0.5 s−1, the worst corrosion resistance behavior from the potentiodynamic polarization test results after deformation at 0.005 s−1 was attributed to more austenite (γ) and ferrite (δ) grain boundaries or δ/γ phase interface formation due to the better effect of γ dynamic recrystallization (DRX) or δ dynamic recovery (DRV). Increasing strain rate to 5 s−1 lowered the corrosion resistance, due to the increase in dislocation density. At the low strain rate of 0.005 s−1, the susceptibility to intergranular corrosion (IGC) was comparatively high after deformation at 1050 and 1150°C with more γ/γ grains and δ/γ phase boundary formation, which was lowered with the strain rate increase to 0.5 s−1, due to suppressing effect of γ DRX.

Originality/value

The paper provides the scientific basis for the practical application of hot working of 2205 duplex stainless steel.

Keywords

Acknowledgements

This work was supported by the National Natural Science Foundation of China (No. 51261010).

Citation

Yang, Y. and Yan, B. (2015), "Effect of high temperature compression deformation strain rate on the microstructure and corrosion behavior of 2205 duplex stainless steel", Anti-Corrosion Methods and Materials, Vol. 62 No. 3, pp. 163-171. https://doi.org/10.1108/ACMM-01-2015-1488

Publisher

:

Emerald Group Publishing Limited

Copyright © 2015, Emerald Group Publishing Limited

Related articles