TY  - JOUR
AB  - Purpose– The purpose of this paper is to analyse the use of a product‐oriented layout and a work‐cell strategy in order to maximise efficiency. These two categories of layout strategies are discussed separately, and are then used collectively in an analysis of the company. The aim is to understand how improvements on layout design could positively impact the future efficiency of the case study company.Design/methodology/approach– A model was developed and measured using 26 weeks of data between the fourth quarter of 2009 and the first quarter of 2010 during layout transformations at the case study company based in upstate New York. The model compared variables such as the distance traveled to retrieve parts, average daily output of engines, labour cost per unit produced, and the amount of time the engine remains in each cell; the aim of which is to increase the efficiency of the facility.Findings– The findings indicate that there is a strong correlation between the variables improved at both the cell‐structures and the product‐structures of the facility and the overall efficiency of the manufacturing facility itself. The results also show that an overall higher efficiency allows for the facility to handle much larger workloads and also drives down both short‐run and long‐run costs. The outcomes also allow for a suggestive redesign of the facility in order to further maximise efficiency. However, it was found that the amount of time a product remains in each cell on the assembly line does not have an effect on the overall output of diesel engines.Research limitations/implications– Various studies have been conducted focusing on the “facility layout problem,” yet thorough analyses of the redesigning of layout in regards to efficiency are not as available. Instead, an understanding of the topic was derived through sources focusing on the specificities of manufacturing layout.Originality/value– This paper describes layout efficiency through redesigns and layout using work‐cells in a product‐oriented environment. This study would be useful to manufacturers having low variability in their product and having the ability to use work‐cell layout within their facility.
VL  - 9
IS  - 3
SN  - 1472-5967
DO  - 10.1108/14725961111148117
UR  - https://doi.org/10.1108/14725961111148117
AU  - Aghazadeh Seyed‐Mahmoud
AU  - Hafeznezami Saeedreza
AU  - Najjar Lotfollah
AU  - Huq Ziaul
PY  - 2011
Y1  - 2011/01/01
TI  - The influence of work‐cells and facility layout on the manufacturing efficiency
T2  - Journal of Facilities Management
PB  - Emerald Group Publishing Limited
SP  - 213
EP  - 224
Y2  - 2024/04/18
ER  -