On the zero offset stability of thick film strain gauges
Article publication date: 1 December 2002
This paper presents results of work aimed at characterising the zero offset stability in novel thick film strain gauges. The devices studied are z‐axis (k33) load sensors fabricated on insulated stainless steel substrates and include examples of novel commercially developed force sensors. Devices loaded with compressive strains using a purpose designed test jig were found to exhibit a significant zero offset shift, which is negative up to a certain level (typically 1,000 micro strains) and then increasingly positive when strained beyond this point. Repeated cycles of loading then produced a certain level of stability until the previous maximum value of applied strain was exceeded. Temperature coefficient of resistance (TCR) measurements showed the devices to exhibit characteristics that depend significantly on the device geometry. The TCR was found to increase positively with increasing device thickness and surface area. The effect of overglazing the devices was found to decrease the TCR.
Zheng, Y., Atkinson, J. and Sion, R. (2002), "On the zero offset stability of thick film strain gauges", Microelectronics International, Vol. 19 No. 3, pp. 24-29. https://doi.org/10.1108/13565360210445014
MCB UP Ltd
Copyright © 2002, MCB UP Limited