To read the full version of this content please select one of the options below:

Reliability of flip chip components soldered on FR5 board

Jarmo Määttänen (Elcoteq Network Corporation, Lohja, Finland)
Petteri Palm (Elcoteq Network Corporation, Lohja, Finland)
Aulis Tuominen (Nokia Research Center, Nokia Group, Finland and Tampere University of Technology, Pori School of Technology and Economics, Pori, Finland)

Microelectronics International

ISSN: 1356-5362

Article publication date: 1 April 2000

Abstract

To achieve good reliability and high performance flip chip interconnection, process parameters and materials used in the flip chip process must be optimised. In this paper reliability of Sn37Pb solder bumped flip chips on an FR5 board, using different fluxes and underfill materials, are tested in a temperature cycling test. Also the contact pad geometry used on the FR5 board had a great influence on the reliability of the joint. The solder bumps were grown on the well‐known TiW/Au under bump metallurgy (UBM1) with an extra layer of nickel (UBM2) which gives a reliable and high performance solder joint.

Keywords

Citation

Määttänen, J., Palm, P. and Tuominen, A. (2000), "Reliability of flip chip components soldered on FR5 board", Microelectronics International, Vol. 17 No. 1, pp. 27-30. https://doi.org/10.1108/13565360010306038

Publisher

:

MCB UP Ltd

Copyright © 2000, MCB UP Limited