TY  - JOUR
AB  - Purpose– The purpose of this paper is to evaluate and discuss colour properties, stability and lightfastness after accelerated exposure in xenon‐arc light apparatus, of 3D ink jet prints produced by using 3D colour printing process.Design/methodology/approach– 3D colour prints were produced using ZCorporation 3D printing method. The samples were divided into groups according to the finishing process applied (untreated, finished with different infiltrants). Colorimetric properties were measured using spectrophotometer. Samples were placed into xenon‐arc based weathering apparatus (Xenotest), using the preset glass filtered sunlight, standard indoor conditions. Colour stability was evaluated as change in colour after repeating the spectrophotometer measurements and comparing spectral and specific colorimetric values of initial and exposed samples.Findings– Based on methodology used, the analysis has shown the changes in colour appearance of differently finished 3D prints, which were mostly attributed to chroma and lightness variations. The colour stability of samples studied noticeably varied and is dependent on colour, percentage of ink coverage and finishing method. Issues of colour and stability of 3D ink jet prints could become important as 3D printing emerges into new application areas, in which the object properties will need to be maintained for a certain amount of time.Research limitations/implications– The research is comparative and is limited to the specific materials and procedures used.Originality/value– The paper describes aspects of colour 3D printing for which the published research and literature data are still, for the most part, lacking. Colour measurements methodology and evaluation of stability described could be of value for further research and for users of the technology.
VL  - 18
IS  - 2
SN  - 1355-2546
DO  - 10.1108/13552541211212104
UR  - https://doi.org/10.1108/13552541211212104
AU  - Stanic Maja
AU  - Lozo Branka
AU  - Gregor Svetec Diana
PY  - 2012
Y1  - 2012/01/01
TI  - Colorimetric properties and stability of 3D prints
T2  - Rapid Prototyping Journal
PB  - Emerald Group Publishing Limited
SP  - 120
EP  - 128
Y2  - 2024/04/19
ER  -