TY - JOUR AB - Purpose– The purpose of this paper is the microstructural and mechanical characterization of a biomedical Ti‐6Al‐4V alloy produced by electron beam melting, and the study of the stability of the as‐built microstructure upon heat treatment.Design/methodology/approach– Ti‐6Al‐4V alloy produced by electron beam melting has been mechanically characterized through tensile and fatigue testing. Its microstructure has been investigated by optical observation after etching and by X‐ray diffractometry analysis. The stability of the microstructure of the as‐built material has been deepened carrying out suitable heat treatments, after an analysis by dilatometry test.Findings– The microstructure of a Ti‐6Al‐4V alloy produced by electron beam melting has a very fine and acicular morphology, because of the intrinsically high‐solidification rate of the process. This microstructure is very stable, and the traditional thermal treatments cannot modify it; the microstructure changes significantly only when an amount of strain is introduced in the material. However, the mechanical properties of the alloy produced by electron beam melting are good.Originality/value– The paper provides evidence of the microstructural stability of the material produced by electron beam melting. Even if the microstructure of the as‐built material is not recommended by the specific ISO standard, the related mechanical properties are fully satisfactory. This is a significant indication from the point of view of the production of Ti‐6Al‐4V orthopaedic and dental prostheses by electron beam melting. VL - 15 IS - 3 SN - 1355-2546 DO - 10.1108/13552540910960262 UR - https://doi.org/10.1108/13552540910960262 AU - Facchini Luca AU - Magalini Emanuele AU - Robotti Pierfrancesco AU - Molinari Alberto PY - 2009 Y1 - 2009/01/01 TI - Microstructure and mechanical properties of Ti‐6Al‐4V produced by electron beam melting of pre‐alloyed powders T2 - Rapid Prototyping Journal PB - Emerald Group Publishing Limited SP - 171 EP - 178 Y2 - 2024/04/20 ER -