Fabrication of a calcium phosphate scaffold with a three dimensional channel network and its application to perfusion culture of stem cells

Abstract

Purpose

The purpose of this paper is to adopt rapid prototyping (RP) technology to fabricate self‐hardening calcium phosphate composite (CPC) scaffolds with a controlled internal channel network to facilitate nutrient supplying and cell growth using RP technique and investigate their in vitro performance.

Design/methodology/approach

Porous scaffolds should possess branched channels to ensure uniform cell feeding and even flow of culture medium to promote uniform cell attachment and growth. A new three dimensional (3D) flow channel structure has been designed based on conversation of energy and flow. The CPC scaffold possessing such a channel network was made by indirect solid free form fabrication. Negative model of scaffold was designed by Pro/E software and its epoxy resin mold was fabricated on a sterolithography apparatus and the CPC slurry was filled in these molds. After CPC was self hardened, the mold was baked. The mold was removed by pyrolysis and then the designed scaffold was obtained.

Findings

The sizes of the fabricated scaffolds were consistent with the designed. The average compressive strength of the scaffold is approximately 6.0 MPa. Computational fluid dynamics and perfusion culture results showed that such a 3D flow channel arrangement would lead to a more uniform distribution of flow and cells and good transportation of nutrients.

Research limitations/implications

The size errors of fabricated scaffolds could not escape and perfusion methods were difficult to control.

Originality/value

The basic design concept presented showed great promise for use in bone tissue engineering and fabrication method enhanced the versatility of scaffold fabrication. The designed scaffold structure made it possible to keep integrality of the scaffold when direct observation cells inside the channel by scanning electron microscopy (SEM).

Citation

Xu, S., Li, D., Lu, B., Tang, Y., Wang, C. and Wang, Z. (2007), "Fabrication of a calcium phosphate scaffold with a three dimensional channel network and its application to perfusion culture of stem cells", Rapid Prototyping Journal, Vol. 13 No. 2, pp. 99-106. https://doi.org/10.1108/13552540710736786