To read this content please select one of the options below:

Modeling and characterization of novel, low‐cost, direct‐write waveguide

M.A. Mignatti (Department of Mechanical Engineering, University of Texas at Austin, Austin, USA)
M.I. Campbell (Department of Mechanical Engineering, University of Texas at Austin, Austin, USA)
R. Ruizpalacios (Department of Mechanical Engineering, University of Texas at Austin, Austin, USA)
K.L. Wood (Department of Mechanical Engineering, University of Texas at Austin, Austin, USA)
J.J. Beaman (Department of Mechanical Engineering, University of Texas at Austin, Austin, USA)

Rapid Prototyping Journal

ISSN: 1355-2546

Article publication date: 1 February 2004

637

Abstract

Both the current long term telecommunication trends toward optical networking and the recent growth in information bandwidth have pushed the necessity for improved optical communications. Our fabrication approach, which leverages our expertise in solid freeform fabrication in conjunction with sol‐gel technology, has advantages over these other methods because of the inherent benefits of using a direct‐write philosophy, such as design flexibility and minimal post‐processing. However, fabrication of such novel optical components requires extensive knowledge of their light guidance capabilities. This paper shows the technical issues involved in both modeling and characterizing small optical components fabricated by locally densifying sol‐gels in a modified direct‐write process.

Keywords

Citation

Mignatti, M.A., Campbell, M.I., Ruizpalacios, R., Wood, K.L. and Beaman, J.J. (2004), "Modeling and characterization of novel, low‐cost, direct‐write waveguide", Rapid Prototyping Journal, Vol. 10 No. 1, pp. 50-57. https://doi.org/10.1108/13552540410512534

Publisher

:

Emerald Group Publishing Limited

Copyright © 2004, Emerald Group Publishing Limited

Related articles