The economic design of • and S² control charts with preventive maintenance and increasing hazard rate

Abstract

Develops the joint economic designs of • and S² control charts under four operating policies to monitor the process in a situation where the occurrence of the assignable cause follows a general distribution with an increasing hazard rate. The four operating policies can be chosen by quality controllers to cope with the specific process situation. Policy I and policy II assume that the process performs the preventive maintenance programme at equal and decreasing sampling time intervals, respectively. Policy III and policy IV in turn merely take samples using the non‐uniform and uniform sampling interval schemes without preventive maintenance. The derivation of the four models is not very difficult, so it can be used to derive another model. Offers numerical examples to compare the economic designs and the total expected costs per hour of the four models. Finds, from the computational results, policy II is the best for adoption in the design of • and S² control charts. The results also show that the proposed solution procedure is more accurate and better than Rahim et al.’s and Chung and Chen’s procedures. Concludes with remarks and some advantages of introducing the periodic preventive maintenance policy into a process.

Citation

Chiu, H. and Huang, B. (1995), "The economic design of • and S² control charts with preventive maintenance and increasing hazard rate", Journal of Quality in Maintenance Engineering, Vol. 1 No. 4, pp. 17-40. https://doi.org/10.1108/13552519510105188